REP25317

• Permit No: M1988112
• IBM Index Class Name: Report
• Doc Date: 3/31/1992
• Doc Name: INSTRUMENTATION LOG
• Media Type: D
• Archive: No

I
are:
1) Supply ~an positive presure air the processor
via a heater, fan and air duct to the outside.
2) Isolate the strip processor from the operating
environment either by sealing off the marshalling panel or by
building another structure around the cabinet.
2) I decided to isolate the strip processor from the
environment, b closing off the lower half of the marshaling
cabinet. I cu~ some metal to fit over the lower vents. I
bolted and sealed them off using silicone.
3)
3/12/92
1 I finished sealing off the marshalling cabinet by packing
the lower section of the cabinet with duct clay.
2) I had to leave at 10:30 for a dental appointment.
3/13/92
1) Cleaned and calibrated the Ph probes.
2~ Worked on trying to get the T35 working on the data
highway.
3/16/92
1) Checked to see what was wrong with the level indioators on
the HCL tank and the caustic Tank. Checked all the
appropriate parameters and made several diagnostic tests,
everything checked out fine except parameter. 3 on the HCL
tank level Parameter. 3 was reading 4 rather than the 15.8
it should have been reading.
2) started to work on Rich Nie's CN equilibrium program.
3) Helped Clairence wire the noise meter.
4) Cleaned and calibrated the Ph probes.
3/17/92
1) Worked most of the day on getting the BMtest program
working for Rich Nie.
2) Vacuumed out the computers, the printers and the UPS in
the control room.
3) Got some material from the warehouse for operations, also
got.some rubber splicing tape and some super 88 vinyl
splicing tape for the electricians.
4) Checked to see if the floc mix pump was working properly,
there didn't seem to be anything wrong with it.
3/18/92
1~ Had to fix the CV2 weight meter, it was reading zero TPH
with the belt full. Found that the tachometer wasn't working