Laserfiche WebLink
_ 2) Got some equ~ent for operation from th arehouse. <br />3~ Finished debugging the BMtest pro ram and I'm waiting on <br />Rich to give me some sample data so hat I could verify the <br />programs correctness. <br />4) <br />3/19/92 <br />1) Ran bmtest a ainst some test data, the program seemed to <br />work fine excep~ that it wasn't producing matching numbers <br />down to the first decimal point. <br />2) Made a modification to the strip plc logic had valve 550 <br />close when strip hold in effect. <br />3) Started calibrating HCN detectors was able to gat the <br />HCN detector above the NaCN tank calibrated. Had problems <br />with the sample bag calibrating the other HCN detectors. <br />4) Valve 224's modulating piston was stuck, so I freed it for <br />operations. <br />3/20/92 <br />3/23/92 <br />1~ Spent much of the day replacing the ph robe in the <br />titration room. The titration room ph probe's membrane was <br />cracked and no longer functioning. I originallyy replaced the <br />probe with a large plastic probe I had purchased for that <br />purpose. Something happened in the software that prevented <br />the ph transmitter from working properly. I had to call for <br />tech support from TBI-Bailey to finally get it working <br />properly. <br />3/24/92 <br />1) Spent most of the morining working on the secruity VCR in <br />the control room office, took the VCR appart and cleaned it <br />out. Cleaned out the cabinet and all the other equipMent in <br />the cabinet. Cleaned out the fan and filter on the back of <br />the cabinet. Moved everything down to the table for easier <br />access to the fan on the back of the cabinet. <br />3/25/92 <br />1) Did a total span calibration of the CV2 weight meter. <br />2) Checked the ball trap, supposedl it was leaking slurry <br />I opened both valves and cleaned hem out while we were <br />down, it seems to be working fine now. <br />3) Tad was complaining about the thickener flow meter. I <br />made a full system check of it and found nothing wrong. <br />4) Added a tilt switch at the top of the SAG chute. <br />5) Had to do some paper work for Karen. <br />