Laserfiche WebLink
.- <br />M-95-005/Adequacy <br />4/4/95 <br />page 2 <br />or drainage. Though the map submitted shows the direction of <br />mining, there is no indication on either map of the stockpile areas <br />for soil or overburden, gravel, processing areas, roads, water <br />tanks, sediment or runoff control structures, mining phases, <br />setbacks from boundaries or in-permit structures, etc. There are <br />two cross-sections shown in the upper part of the map, but their <br />details are not legible. If you wish to include these details, <br />please make them larger. You may want to depict the pre-existing <br />disturbance on the pre-mining map. If you plan to modify the <br />boundary slightly as you had mentioned, in the area of the northern <br />point, show that on the map. Please review Rules 6.2.1(2) and <br />6.4.3 for complete details about map requirements. <br />EXHIBIT D - MINING PLAN <br />Please describe where or how topsoil and/or overburden will be <br />stripped before mining, and then stockpiled. In your situation, if <br />the topsoil is stockpiled along the north edge of the pit, please <br />describe exactly where in relation to the scarp it will be placed, <br />so as to not erode down the hill (offsite). If the plan is to <br />phase the mining, or only allow a certain maximum amount of acreage <br />to be disturbed at one time, please state this. Please state what <br />the slopes angles will be during mining and afterward. These <br />details will become part of your plan and will affect your bond <br />amount too. You stated that though there is usually a shale layer <br />underlying the gravels in this region, you rarely encounter a <br />uniform shale floor. Where shale is encountered, ripping, <br />backfilling or grading occurs so shale is not left exposed. (Shale <br />outcrops do not naturally occur in this permit area, indicating <br />that there is little likelihood of encountering an underlying shale <br />floor. Seeps and instability from surface shear are concerns <br />regarding an underlying shale seam.) At least a foot of gravel <br />cover will be left or replaced for later coverage of topsoiling and <br />seeding. Be reminded that all activity and disturbance related to <br />this operation must fall within the permit area boundary which you <br />decide on. Remember that if your operation will affect land within <br />r~We~(, 200 feet of a significant structure, you must prove that the <br />°'` ~ operation will not adversely affect it, or provide evidence that a <br />damage/mitigation agreement exists with the owner of that <br />structure. <br />EXHIBIT E - RECLAMATION PLAN <br />You have stated that a minimum of four inches of topsoil will be <br />replaced after mining. I encourage you to save all the topsoil <br />possible, for later replacement, rather than exporting some portion <br />of it offsite. If applicable, also state the average thickness of <br />overburden or other material which will be replaced before the <br />topsoil. During the site visit I noticed that the hillsides have <br />much less soil (and grass) than the mesa tops. All "excess" soil <br />or material produced during mining which is suitable as a growth <br />