Laserfiche WebLink
<br />wetland areas have been enlarged to reflect the fact that seasonally flooded <br />depressions and not ponds will be constructed as a part of the final reclamation <br />plan at this location. <br />~(~~ 14. On the Reclamation Plan Map #4 the south pit has a bottom elevation of 6630'. <br />This elevation appears to be the same elevation noted on the pre-mining map <br />in the same location. How is this possible if the area is to be mined of gravel <br />ranging from 13' to 48' thick? As noted above, it is difFcult to read the <br />contour intervals and elevation due to the map size. Please clarify this <br />discrepancy. <br />Response: The elevation of 6630' mentioned as occurring as the bottom <br />elevation of the south pit is an error on the map, which was prepared showing <br />the potential final elevations following the cessation of mining operations. For <br />some unexplained reason, when we turned off the premining contour lines in <br />AutoCAD, the elevational intervals remained. We had not observed this mistake <br />and all of the premining elevations have been corrected on Map # 4, Tellier <br />Gravel Pit -Reclamation Plan Map. <br />The DMG is incorrect in suggesting that the thickness of the gravel ranges from <br />13 to 48 feet and averages 19.9 feet in thickness. Their statement comes from <br />item 4. Thickness of Gravel to be Mined which states "the depth of gravel ranges <br />from approximately 13 feet to upwards of 48 feet, and averages 19.9 in <br />thickness." Due to confidentially reasons, the measurements for gravel thickness <br />are not presented in this Permit Application and only generalized terms are used. <br />The only place 48 feet is used in this Permit Application is to describe the "depth <br />of gravel" and the average thickness of gravel is 19.9 feet. <br />As a result of excavating approximately 20 feet of gravel, the elevations <br />associated with the final reclamation should be dropped an equivalent amount. <br />When we prepared our final reclamation contour map we assumed that across <br />the entire mine site elevations would be approximately 20 feet lower than the <br />preexisting elevations. This is why the term approximate original contour is used <br />in mined land reclamation. In this vein, when the elevations found on Map # 2, <br />Tellier Gravel Pit -Premining Conditions Map are compared with the proposed <br />elevations found on Map # 4, Tellier Gravel Pit -Reclamation Plan Map, it can <br />be observed that the elevations in the proposed mine pit area when reclaimed <br />will be approximately 20 feet lower in elevation. Examination of the elevations <br />shown on Map # 4, Tellier Gravel Pit -Reclamation Plan Map with the premining <br />elevations found on Map 2, Tellier Gravel Pit -Premining Conditions Map shows <br />that the existing elevation in the center of the Phase II pit near the middle of the <br />2010 year mining block averages 6622 feet in elevation. While the elevation off <br />Map # 4, Tellier Gravel Pit -Reclamation Plan Map shows the elevation after <br />mining to be approximately 6606 feet. <br />10 <br />