Laserfiche WebLink
4.05.12 Protection of Groundwater Recharge Caoaci <br />• The reclamation plan, as described in Section 2.05.4, will return the <br />disturbed land to approximately the pre-mining condition; therefore, <br />groundwater recharge capability is expected to remain essentially the <br />same as the pre-mining condition. Also, because of the lack of <br />groundwater in the permit area, the mining operation and subsequent <br />reclamation and sealing of the portals should have no adverse affect on <br />the existing groundwater recharge capabilities. <br />4.05.13 Surface and Groundwater Monitori <br />Because no groundwater has been or is expected to be encountered, no <br />groundwater monitoring is planned. <br />The planned surface water monitoring plan includes monitoring required <br />under an NPDES Permit to be issued by the Colorado Department of Health. <br />Surface water monitoring locations are shown on the Mine Facilities Map <br />• (Map 12). Surface water samples will be analyzed for pH, total <br />suspended solids (TSS), total dissolved solids (TDS), iron, manganese, <br />oil and grease content, and other parameters that may be required by the <br />NPDES Permit. Peerless Resources will measure the quantity and quality <br />of any discharge from the sedimentation pond in compliance with the <br />NPDES Permit. <br />Peerless Resources will report on discharge in accordance with the Clean <br />Water Act of 1977 under an NPDES Permit on an annual basis; therefore, <br />Peerless Resources will plan to use the NPDES report for filing with the <br />Division. <br />Following the cessation of use of underground mine workings, Peerless <br />Resources will continue to monitor surface water flow and quality until <br />determined that the reclamation has met the requirements of Section <br />4.05, such that the disturbance has minimized any impact to the <br />• prevailing hydrologic balance and the post-mining land use has been <br />attained. Equipment, structures, and other devices necessary to measure <br />4.05-9 <br />