_REVISION - M1980244 ‎(30)‎

• Permit No: M1980244
• IBM Index Class Name: Revision
• Doc Name: Appendix E
• From: Cripple Creek & Victor Gold
• To: DMG
• Type & Sequence: AM8
• Media Type: D
• Archive: No

2.02 MANUFACTURER QUALITY CONTROL:
CONTRACTOR shall enswe that geogrid MANUFACTURER meets [he conditions in this section.
• A. Geogrid Tests and Inspection
1. Geogrid MANUFACTURER shall perform quality control testing of the geogrid.
Samples not satisfying specifications shall result m [he rejection of applicable rolls. At
a minimum, the following tests shall be performed for quality control in accordance
with test methods specified in Table 2.01.
a. Density
b. Mass per unit area
o. Thickness
d. Carbon black content
2. At geogrid MANUFACTURER'S discretion and expense, additional testing of
individual rolls may be performed to more closely identify noncomplying rolls and to
qualify individual rolls.
3. Geogrid manufactwer shall perform quality control tests at a frequency of at least every
50,000 ft' of geogrid produced.
PART 3: EXECUTION
3.01 EXAMINATIONS:
. A. Conformance Testing
1. Geogrid manufacturer shall supply samples of geogrid to CQA ENGINEER for
conformance testing. Unless otherwise specified, samples shall be taken at a rate of one
per lot, not to exceed one conformance test per 100,000 square feet of geogrid.
2.
3.
3.02 INSTALLATION:
For geogrid, the following tests shall be performed using the procedures listed in
Exhibit C:
a. Mass per unit area
b. Aperture size
c. Wide strip tensile strength
d. Node strength
Geogrid shall be rejected if conformance test results do not meet or exceed the values
presented in Table 2.01.
A. Geogrid Deployment
1. No equipment or tools shall damage the geogrid by handling, trafficking, or other
means.
Section 02776.1 Page 4 of 5 December 9, 1998
Geogrid Golder Associates Revision 3
D:\PFIASEIV PSSA CERl1APPENDIC1E541PPENDIX E TECFEVICAL SPECIFICATIONS\02TlT 61RJ.DOC