Laserfiche WebLink
4.3 Where bolt holes and bolt groupings are specified, they shall be punched or <br />drilled to final dimension. Torch cut holes will not be acceptable. <br />4.4 Prior to final painting, all components of matching assembly shall be <br />assembled in the shop to verify alignment and fitting. <br />4.5 After shop verification of alignment, all components that will be exposed <br />shall be sand blasted and painted with one primer coat and 2 finish coats. <br />4.6 All components or faces of components to be embedded in concrete shall <br />be sand blasted, and primed and painted per the above Specifications. <br />5 INSTALLATION <br />5.1 Assemblies shall be installed per the manufacturer's instructions, and to <br />the lines and grades shown on the Drawings. <br />5.2 Any field modifications to fabricated assemblies shall be cleaned, primed, <br />and touched up with the specified paint system or per the manufacturer's <br />recommendations. <br />D:V 333.15C\2003 update\SPECS\SPEC D.tloc <br />SPEC. D -STRUCTURAL <br />PAGE 3 <br />