Laserfiche WebLink
BATTLE MOUNTAIN RESOURCES Page 1-3 <br />San Lms Project Technical Specifications <br />conditions shall be considered by the Contractor before resuming construction. Fill placed on <br />frozen or overly wet surfaces shall be considered unacceptable, as determined b:,+ the Designer, <br />and removed at the Contractor's expense. Equipment shall not be allowed to travel on fill or in <br />situ materials until the material has dried sufficiently to prevent excessive rutting and to allow <br />the equipment to be operated satisfactorily. If such rutting does occur, the Contractor shall re- <br />level, scarify, dry and replace the material to whatever depth is required, with the re-leveling and <br />scarifying being at the Contractor's expense. <br />The Contractor shall maintain al] fill placed in a condition satisfactory to the Designer. <br />The Contractor shall take such steps as are necessary to avoid ponding of water on the fill or <br />contamination of the fill by any cause, and shall at all time keep the fill surface mmd slopes free <br />from rubbish, rejected or unsuitable fill, or waste materials. <br />1.4 Schedule of Work <br />The Contractor shall develop a schedule of work for the Designer's approval to complete the <br />construction. In no instance shall approval by the Designer be considered to absolve the <br />Contractor from the responsibility of performing the required work or of protecting the work in <br />interim work stages, or from protecting the work completed prior to final acceptance by the <br />Designer. <br />In preparing the work sequence, the necessity of obtaining borrow from mandatory excavations <br />within the work azea and azeas subsequently requiring fill placement shall be considered. The <br />Contractor shall be awaze of the requirement for selective borrowing from approved borrow <br />sources. <br />The following is a suggested general work sequence for constructing the facilities shown on the <br />Drawings. II is intended as a guideline for the Contractor to develop his own work sequence in <br />conjunction with that of the Owner to suit construction equipment and manpower scheduling and <br />meet design requirements. Additional activities required to complete the work, as outlined <br />within the Specifications and as shown on the Drawings, shall be added by the Contractor. <br />West Pit Culvert Installation: <br />• Develop access roads to work azeas, as needed. <br />• Develop a site drainage plan and maintenance scheme including storm runoff sediment <br />control measures. <br />N:\DHALLMAMSANLUIS~SANLUIS.DOC SH.K Project No 14732 <br />June 4,1997 <br />