PERMFILE46297

• Permit No: M1988112
• IBM Index Class Name: Permit File
• Doc Date: 11/8/1988
• Section_Exhibit Name: APPENDIX N TECHNICAL SPECIFICATIONS
• Media Type: D
• Archive: No

' 6.0 FILL PLACEMENT AND COMPACTION
Fill materials shall be placed to the lines and grades shown in the
drawings. Fill slopes shall not exceed 2H:1V unless otherwise shown in
the drawings or directed by the Engineer.
6.1 Fill Placement (General)
No materials shall be placed until the foundation end subgrade
preparations have been completed as specified and approved by the
Engineer. The procedures for the construction of the fills shall be
' discussed with and approved by the Engineer prior to start of fill
placement.

No brush, roo ts, sod , or other deleterious or unsuitable
' materials shall be
i
l
i
d
t
t
d placed
f in the fill
fill
ill s. The suitability of
b
b
l all
b
ma
er
n
a
s
en
e or use as
w e su
ject to approva y
the Engineer. Fill shall not be placed upon saturated surfaces nor
upon loose wind blown materials. Fill placement shall be
temporarily stopped due to unsuitable weather conditions such as
wind storms or thunderstorms upon the direction of the Engineer.
If the surface of the prepared foundation or the surface of
any layer of the fill is too dry or too smooth toibond properly
' with the layer of material to be placed thereon, it shall be
moistened andJor worked with harrow, scarifier, or other equipment
to provide a satisfactory bonding surface before the next layer of
fill material is placed. If the surface of the prepared foundation
or the rolled surface of any layer of the fill in-place is too we*.
for proper compaction of the layer of fill material to be placed
thereon, it shall be removed and allowed to dry or is shall be
' worked with harrow, scarifier, or other equipment to reduce the
moisture content to the required amount. It shall then bE~ compacted
before the next layer of fill material is placed. Determination of
such dry or wet conditions shall be by the Engineer.

N-10