2022-06-24_PERMIT FILE - C1980007 ‎(2)‎

• Permit No: C1980007
• IBM Index Class Name: Permit File
• Doc Date: 6/24/2022
• Section_Exhibit Name: EXHIBIT 68 Major Building & Structures As-Built Summary
• Media Type: D
• Archive: No

- • E. Paint
Metal primer paint; red lead mixed pigment, alkyd varnish, linseed oil paint,
F. S. TT-P-86, Type II; or red lead iron oxide, raw linseed o~1, alkyd paint,
SSPC Paint A-64; or basic lead silico chromate base iron oxide, linseed oil,
alkyd paint, F.S. TT-P-615, Type II. Primer selected must be compatible
with finish coats of paint. Coordinate selection of metal primer with finish
paint requirements specified in Section "Painting."
~ F. Galvanizing Repair Paint
High zinc dust content paint for regalvanizing welds in galvanized steel,
complying with Military Specification MI1rP-21035 (Ships). Z.R.C. by
Sealube Co., or equivalent.
- Part 3 -EXECUTION
3.01 -Fabrication
~_ Form materials so shapes indicated with straight lines, sharp angles, smooth curves.
Drill or punch holes and smooth edges. Weld permanent shop connections. All
welds continuous fillet type. Grind smooth, welds that will be exposed. Conceal
fastenings where practicable. Punch or drill for temporary field connections and
for attachment of work by other trades. Fabricate work in shop in as large
• assemblies es is practicable. Meet requirements specified under Structural Steel
r for fabricating items of structural nature or use. Qualify welding processes and
~;:i welding operators in accordance with AWS "Standard Qualification Procedure."
3.02 -Shop Painting
A. Remove scale, rust and other deleterious materials before applying shop
coat. Clean off heavy rust and loose mill scale in accordance with SSPC SP-
2 "Hand Tool Cleaning," or SSPC SP-3 "Power Tool Cleaning," or SSPC SP-7
~- "Brush-Off Blast Cleaning." Remove oil, grease end similar contaminants in
_ accordance with manufacturer's instructions, and at rate to provide uniform
dry film thickness of 2.0 mils for each coat. Use painting methods which
will result in full coverage of joints, corners, edges and exposed surfaces.
i- B. Immediately after surface preparation, brush or spray on primer in
,4 accordance with manufacturer's instructions, and at rate to provide uniform
dry film thickness of 2.0 mils for each coat. Use painting methods which
will result in full coverage of joints, corners, edges and exposed surfaces.
-~ C. Apply one shop applied primer coat to all ferrous metal not indicated to be
set in or receive concrete. Thoroughly clean off foreign matter prior to
L shop priming.
D. Apply 2 shop coats to ferrous metals that will be inaccessible after erection.
L . E. For painted metals use asphaltic paint on those metals anchored into
masonry or concrete.
-~~ 05100-3
i