2019-12-13_REVISION - M1980244 (60)

Home Browse Search

ResponseSpill NORTHNEWMONT Countermeasures Plan for the Cresson Project Sustain_. ility& External Relations 40 CFR(1) Requirement* Location in Plan 112.7(f)(3) Conduct discharge prevention briefings for oil-handling personnel at least once a year. Discuss known discharges,failures, malfunctions, and recently developed Section 3.7 precautionary measures. 112.7(g) Fully fence facilities handling, processing, and/or storing oil; and lock and/or guard entrance gates when the Facility is unattended or not in production. Section 3.3 Provide adequate security to ensure that master flow and drain valves remain locked when the Facility is unattended or not in production. Section 3.3 Lock oil pump starter controls in the"off' position,and locate the controls at locations accessible only to authorized personnel. Section 3.3 Securely cap or blank flange the loading/unloading connections of oil pipelines or Facility piping if the piping is not in service or on stand-by status for an extended Section 3.3 time. Provide sufficient lighting to allow the discovery of discharges and to prevent discharges occurring through acts of vandalism. Section 3.3 112.7(h)(1) Where drainage from the unloading area does not flow into a catchment basin or a Section 1.4 treatment Facility, use a quick drainage system or a containment system which Section 3.1 holds the largest compartment of any tank car or truck. Section 4.8.1 112.7(h)(2) Provide an interlocked warning light or brake interlock system, physical barrier system,wheel chocks,or warning signs to prevent the departure of vehicles before Section 3.6 all oil transfer lines are disconnected. 112.7(h)(3) Prior to filling and departure, inspect the lowermost drain and all outlets for leakage Section 3.6 on the tank car/tank truck,and adjust to prevent discharge while in transit. Appendix H 112.7(i) If a field-constructed aboveground container undergoes repair, alteration, reconstruction, or change in service that may affect the risk of a discharge or failure, due to brittle fracture or other catastrophe, or has discharged oil or failed due to Section 4.1.1 brittle fracture failure or other catastrophe,evaluate the container for risk of discharge or failure due to brittle fracture or catastrophe and as necessary take appropriate action. 112.7(j) Provide a complete discussion of the conformance of the plan to all other applicable discharge prevention and containment requirements,or any applicable more Section 4.9.4 stringent State rules, regulations, and guidelines. 112.7(k) In lieu of general secondary containment required in paragraph (c)of this section, implement for qualified oil-filled operational equipment the Section 4.9 alternate requirements as described in paragraph (k)(2)of this sub-section,as Section 4.10 follows: (2)(i) Establish and document the facility procedures for inspections or a monitoring Section 4.10 program to detect equipment failure and/or a discharge for qualified oil-filled operational equipment without secondary containment. Appendix A (2)(ii) For qualified oil-filled equipment without secondary containment, provide the following: (A)An oil spill contingency plan following the provisions of Part 109 of Section 4.10 this chapter; (B)A written commitment of manpower, equipment, and materials Section 5.0 required to expeditiously control and remove any quantity of oil discharged that may be harmful. 112.8(b)(1) Restrain drainage from diked storage areas by valves or other positive means to prevent an oil discharge or excessive leakage into the Facility drainage or effluent Section 4.1.3 treatment system. 112.8(b)(2) Use valves of the manual,open-and-closed design for the drainage of diked area Section 4.1.3 ---------------------------------------------------------------------------------------------------------- - - Department THIS DOCUMENT IS UNCONTROLLED IN HARDCOPY FORMAT Doc Id:NA-CCV-SER-PLAN- 1930