2019-12-13_REVISION - M1980244 ‎(60)‎

• Permit No: M1980244
• IBM Index Class Name: Revision
• Doc Date: 12/13/2019
• Doc Name Note: Appendix 10 - 11
• Doc Name: Request For Amendment To Permit
• From: CC&V
• To: DRMS
• Type & Sequence: AM13
• Email Name: TC1
• Email Name: MAC
• Email Name: BFB
• Email Name: ERR
• Email Name: JPL
• Media Type: D
• Archive: No

Spill . .
NORTHNEWMONT Countermeasures Plan for the Cresson Project
.•
Table 2:SPCC Cross-Reference
40 CFR(1) Requirement* Location in
Plan
112.3(d) Have the SPCC plan certified by a registered professional engineer. Section 2.2
112.3(e)(1) Maintain a copy of the plan at your Facility. Section 2.4
112.3(e)(2) Have a copy of the plan on-Site for review by the Agency. Section 2.4
112.4(a) Whenever your Facility discharges>1,000 gallons of oil in a single discharge or has
two discharges of>42 gallons within 12 months,submit the information described Section 3.4.3
in 112.4(a)(1)-(9)to the regional administrator within 60 days.
112.4(c) Send to the State a copy of the information submitted to the regional administrator. Section 1.1
112.4(d) Amend the plan if required to do so by the regional administrator. Section 2.5
112.5(a) Amend the plan when there is any change that materially affects the potential for a
discharge. Section 2.5
Implement any amendment within 6 months.
112.5(c) Have technical amendments certified by a registered professional engineer in
Section 2.5
accordance with 40 CFR 112.3(d)except as provided in 40 CFR 112.6.
112.7 Management must give full approval to the plan and the authority to commit
Section 2.1
resources.
112.7 The plan must either follow the sequence of§112.7; or must be an equivalent plan,
which includes all applicable SPCC requirements,with a cross-reference to the 40 Table 2
CFR 112 requirements.
112.7(a)(1) Include a discussion of Facility's conformance with the requirements listed in Part
Section 1.1.1
112.
112.7(a)(2) Where the plan does not conform to the applicable requirements [see regulations],
then:
state the reasons for nonconformance, Section 1.2.2
describe in detail alternate methods and how equivalent environmental
protection will be achieved.
112.7(a)(3) Describe the physical layout of the Facility, and include a diagram which shows the
location and contents of each container. Section 4
Include completely buried tanks that are exempted from 40 CFR 112 Tables 3-10
requirements. Figures 3-9
• Include all transfer stations and connecting pipes.
112.7(a)(3) Address:
(i) the type of oil in each container and its storage capacity; Tables 3-10
(ii) discharge prevention measures, including procedures for routine handling of
Section 4
products;
(iii) discharge or drainage controls around containers and other
Section 4
structures, equipment, and other procedures for controlling a discharge;
(iv) countermeasures for discharge discovery, response,and cleanup by the Facility
Section 4
and that might be required of a contractor;
(v) methods of disposal recovered materials in accordance with applicable legal
Section 5.5.3
requirements; and
(vi) contact list and phone numbers for the Facility response coordinator, National ERP under the
Response Center, clean-up contractors,and all appropriate Federal,State, and local CONTACTS tab
agencies.
112.7(a)(4) Provide information and procedures in your plan to enable a person reporting a
discharge to provide the information described in 112.7(a)(4). Section 5.6
- --------- - . ............ _-------_. -.,_ ..,,. --- - ----- ------- --- - .-
Department THIS DOCUMENT IS UNCONTROLLED IN HARDCOPY FORMAT Doc Id:NA CCV-SER PLAN-
1930