Laserfiche WebLink
AraZ Laboratories, Inc. <br />2773 Downhill Drive Steamboat Springs, CO 80487 (800) 334-5493 <br />Golder Associates ACZ Project ID: L44806 <br />.h$ii.j,,. y`: '�- lw —`�z ^$�5�.�•r" „w w- ,,�- -...-,.-.-�m,yF ,- <br />e ✓ r <br />Q6 <br />SM4500H+ B <br />Q6 <br />,� <br />L44806-05 NG449751 Bicarbonateyas CaCO3 <br />SM23206 - Titration <br />Q6 <br />Sample was received above recommended temperature <br />W G449740 Calcium, dissolved <br />M200.7 ICP <br />M3 <br />The spike recovery value is unusable since the analyte <br />Q6 <br />concentration in the sample is disproportionate to the spike <br />level. The recovery of the associated control sample (LCS <br />or LFB) was acceptable. <br />WG449751 Carbonate as CaCO3 <br />SM2320B - Titration <br />Q6 <br />Sample was received above recommended temperature. <br />WG450092 Chloride <br />M300.0 - Ion Chromatography <br />DC <br />Sample required dilution. Non -target analyte exceeded <br />calibration range. <br />M300.0 - Ion Chromatography <br />Q6 <br />Sample was received above recommended temperature. <br />M300.0 - ton Chromatography <br />RA <br />Relative Percent Difference (RPD) was not used for data <br />validation because the concentration of the duplicated <br />sample is too low for accurate evaluation (< 1 Ox MDL) <br />WG449751 Hydroxide as CaCO3 <br />SM2320B - Titration <br />Q6 <br />Sample was received above recommended temperature. <br />pH <br />SM4500H+ B <br />Q6 <br />Sample was received above recommended temperature. <br />pH measured at <br />SM4500H+ B <br />Q6 <br />Sample was received above recommended temperature. <br />WG449609 Residue, Filterable (TDS) @180C <br />SM2540C <br />HC <br />Initial analysis within holding time. Reanalysis was past <br />holding time, which was required due to a QC failure during <br />the initial analysis. <br />SM2540C <br />N1 <br />See Case Narrative <br />SM2540C <br />Q6 <br />Sample was received above recommended temperature. <br />WG450092 Sulfate <br />M300.0 - Ion Chromatography <br />Q6 <br />Sample was received above recommended temperature <br />WG449751 Total Alkalinity <br />SM2320B - Titration <br />Q6 <br />Sample was received above recommended temperature <br />L44806-06 NG449751 Bicarbonate as CaCO3 <br />WG449740 Calcium, dissolved <br />WG449751 Carbonate as CaCO3 <br />WG450092 Chloride <br />WG449751 Hydroxide as CaCC3 <br />pH <br />pH measured at <br />WG449432 Residue, Filterable (TDS) @180C <br />WG450092 Sulfate <br />WG449751 Total Alkalinity <br />REPAD.15.06.05.01 <br />SM2320B - Titration 06 <br />M200.7 ICP M3 <br />SM2320B - Titration Q6 <br />M300.0 - Ion Chromatography Q6 <br />M300.0 - Ion Chromatography RA <br />SM2320B - Titration <br />Q6 <br />SM4500H+ B <br />Q6 <br />SM4500H+ B <br />Q6 <br />SM2540C <br />Q6 <br />M300 0 - Ion Chromatography <br />DC <br />M300.0 - Ion Chromatography <br />Q6 <br />SM2320B - Titration <br />Q6 <br />Sample was received above recommended temperature <br />The spike recovery value is unusable since the analyte <br />concentration in the sample is disproportionate to the spike <br />level The recovery of the associated control sample (LCS <br />or LFB) was acceptable <br />Sample was received above recommended temperature. <br />Sample was received above recommended temperature <br />Relative Percent Difference (RPD) was not used for data <br />validation because the concentration of the duplicated <br />sample is too low for accurate evaluation (< 1 O MDL) <br />Sample was received above recommended temperature <br />Sample was received above recommended temperature. <br />Sample was received above recommended temperature <br />Sample was received above recommended temperature. <br />Sample required dilution. Non -target analyte exceeded <br />calibration range <br />Sample was received above recommended temperature <br />Sample was received above recommended temperature. <br />L44806-1807031405 Page 19 of 24 <br />