Laserfiche WebLink
Newmont‐Cripple Creek & Victor Gold Mine  <br />Technical Specification No. 02210.DOCX  <br />Squaw Gulch VLF  <br />Project No.475.0106.006  <br />August 25, 2016  <br />  <br />  <br />  <br />Page 2  <br />2. PART 2:  PRODUCTS  <br />2.1. Materials  <br />A. Fill materials will consist of Structural Fill, Select Structural Fill, and Coarse Shaft Backfill  <br />identified in  Section  2200.0,  Cast‐In‐Place  Concrete  identified  in  Section  3300.0  and  <br />Cemented Rockfill identified in Section 3310.0.  <br />3. PART 3:  EXECUTION  <br />3.1. Excavation  <br />A. The CONTRACTOR will be responsible for the safety of temporary construction slopes.  <br />CONTRACTOR shall inspect all temporary and permanent open‐cut excavations on a  <br />regular basis for signs of instability. Should signs of instability be noted, CONTRACTOR  <br />shall immediately undertake remedial measures and shall notify MANAGER immediately.  <br />Permanent cut slopes shall be left in smooth, safe, and stable condition at the end of the  <br />workday.  <br />B. CONTRACTOR shall conduct all excavation and shoring operations in compliance with  <br />applicable Colorado State and Federal government laws and regulations.  <br />3.2. Fill Placement  <br />A. Structural Fill  <br />1. CONTRACTOR shall  condition,  place  and  compact  Structural  Fill  by  a  method  <br />compaction technique, as discussed in Section 2200.0.  <br />Maximum rock size for rock fill shall be two‐thirds of the compacted lift thickness,  <br />unless  otherwise  approved  by MANAGER, DESIGN  ENGINEER, and CERTIFYING  <br />ENGINEER. CONTRACTOR shall remove oversize materials from fills at no  additional  <br />cost to CC&V.  <br />B. Select Structural Fill  <br />2. CONTRACTOR shall condition and compact the Select Structural Fill using a method  <br />specification on 3‐foot thick lifts that result in a firm surface that will be approved  <br />by the CERTIFYING ENGINEER.  <br />C. Coarse Shaft Backfill  <br />1. Coarse  Shaft  Backfill  shall  be  placed  in  the  underground  workings as part of  <br />remediation, as shown in the DRAWINGS.  <br />2. CONTRACTOR shall compact and condition the final surface of the Coarse Shaft  <br />Backfill  using  a  method  specification  that  results  in  a  firm  surface  that  will  be  <br />approved by CERTIFYING ENGINEER.