2004-06-29_PERMIT FILE - C1981038 (8)

Home Browse Search

STATE HIGHWAY ACCESS PERMIT #399056 June 7, 199 Issued to Bowie Resources. Inc. TERMS & CONDITIONS (cont'd) noted on [hr design plans. The Colorado Registered Professional Engineer shall seal the.plans in accordance with CRS 12-'_5-I 17 in addition on the first page of the design plans that the following note is required: "This design is in full compliance R'ith Section 4 Of the.State Hi:hw•ay Access Cody.'' CCR 601-I except for [he following approved variances:' [vote: ALL plans mus[ he submi«ed on 11" x 17" sheets at a minimum scale of I"= ?0'. No other plan sheet sizes are authorized. Location drawings may be submitted a[ other scales az approved. 24. All construction work mu;[ he under the direction of a Colorado Recistered Professional Eneineer and upon comple[ion of the work. that responsible Ensineer shall submit an "As Built' plans. showins in detail all approved construction chan~_es, moditications and revisions. The "As Built' Plans must be sealed in accordance w•i[h CRS 25. It shall be the responsibility of the Permi[[ee to verify the location of the existing utilities and notify all utility owners or operators of any work that might involve utilities within the State Highway right-of--way. Any work necessar}• to protect existing permitted utilities, such az an encasement will be the responsibility of the Permit[ee. Any damage or disruption [o any utilities during the construction shall be the Permittee's responsibility and shall be repaired or replaced at no cost to the Depattment. 26. Any damage to any present highway facili[ies including vaffic convol devices shall be repaired immediately at no cos[ to [he Departmen[ and prior to continuing other work. Any mud or other material vacked or o[herwise deposited on [he roadway shall be removed daily or az ordered by the Depanmen[ inspec[or. • 27. Areas of roadway and/or right-of-way disturbed during this installation shall be restored to their orisinal condi[ions. to insure proper streng[h. drainage and erosion convol. 28. Any incomplete construction activity on the State Highway that must be lef[ overnigh[. shall be barricaded and signed in accordance with the Manual on Uniform Traffic Convol Devices and other applicable standards. 29. Open cuts, which are 6 inches in depth, within 30 feet of the edge of [he State Highway vaveled way, wilt no[ be left open at nigh[, on weekends, or on holidays. 30. No more than 6 feet of trench areas shall be opened at any one time. Open venches and other excavations within the State Highway right-of-way shall be backfilled and/or paved before 330 P.M. of each working day or be protected in accordance with the M.U.T.C.D. ~" 31. The area around the new work shall be well graded to drain. top soiled, fettilized. mulched and re-seeded in accordance with the Department standard specifications. 32. When i[ is necessary to remove any highway righ[-of-w•ay fence, the posts on either side of [he access envance shall be securely braced with approved end posts and in conformance with the Depanment's M-607-I standard, before the fence is cut, to prevent slacking of the remaining fence. Ail posts and wire removed shall be returned to the Departmen[. 33. All excavations for unlit) lines. culver[s. venches or tunnels shall meet the requiremen[s of the Occupational, Safety and Health Administration (OSHA). Colorado Indusvial Commission, Colorado Division of Mines or the Colorado Depanmen[ of Transportation, whichever applies. 34. All work that requires traffic control shall be supervised by a registered professional vaffic engineer or by a vaffic control supervisor certified by the American Traffic Safety Services Association (ATSSA) or the Colorado Contractors Association (CCA). When fla~sins personnel are required, the contractor in accordance with the Department standards shall cer[ify them. ~- 35. Construction traffic control devices, when not in use, shall be removed or [urned away from traffic. 36. All temporary pavement striping shall be done by the Permi«ee/contractor in conformance with section 6'_7 of The Department's standard specifications (or Road and Bridge Construction (latest edition). z.