2014-02-07_REPORT - M1980244 ‎(8)‎

• Permit No: M1980244
• IBM Index Class Name: Report
• Doc Date: 2/7/2014
• Doc Name: Final Report QA Monitoring and testing volume 2 of 2 document 1 of 3Mill Site Earth works
• From: CC&V
• To: DRMS
• Email Name: TC1
• Media Type: D
• Archive: No

ameO
17. If tests indicate the Work does not meet the requirements of the SPECIFICATIONS,
MANAGER and CERTIFYING ENGINEER will establish the extent of the
nonconforming area. The nonconforming area shall be reworked by CONTRACTOR
until acceptable test results are obtained at no additional cost to CC&V
18. Prior to any geosynthetics being placed on Soil Liner Fill, the area will be tested by CQA
Monitor. No geosynthetics will be allowed to be placed on frozen material, as defined in
Section 3.06,unless approved by the CERTIFYING ENGINEER.
F. Drain Cover Fill
1. Drain Cover Fill shall be placed over the geomembrane in the locations shown on the
DRAWINGS.
2. Prior to placing the Drain Cover Fill, CONTRACTOR shall verify by visual inspection
that the underlying geosynthetics are free of holes, tears, wrinkles, or foreign objects.
MANAGER and CERTIFYING ENGINEER will inspect the geosynthetic for wrinkles
prior to placement of Drain Cover Fill. As instructed by MANAGER, CONTRACTOR
shall "work out" wrinkles to the satisfaction of MANAGER and CERTIFYING
ENGINEER prior to placement of the Drain Cover Fill. In all cases,wrinkles shall not be
of a size that they could fold back on themselves. Wrinkles greater than one foot shall be
removed and repaired by the INSTALLER.
3. CONTRACTOR shall place Drain Cover Fill in a single 24-inch loose lift. The tracked
equipment shall operate only over previously placed Drain Cover Fill. CONTRACTOR
shall not operate equipment directly on geosynthetics. Only a dozer with a ground pressure
not exceeding 8.7 psi can be used to place Drain Cover Fill. A CAT 12G motor grader,or
equivalent approved by CERTIFYING ENGINEER, can be used for Drain Cover Fill
final grading. Equipment used for placement will not be allowed to pivot on one track(i.e.,
no abrupt or sharp turns). There shall be no downhill placement on slopes steeper than
4H:IV. Material can be placed along contours if buttressed from below. Motor graders
shall not be allowed to make abrupt turns,brake suddenly, or dig blade in which results in
the tires spinning on the Drain Cover Fill surface.
4. Highway compatible Rubber tired construction equipment shall not be allowed to travel
over the geomembrane or on top of geomembrane unless a thickness of at least 45 inches of
Drain Cover Fill has been placed over the geomembrane. The CONTRACTOR will be
required to demonstrate to the MANAGER, DESIGN ENGINEER and CERTIFYING
ENGINEER that the equipment and procedures used are not detrimental to the
geomembrane,at no cost to CC&V. Off road haul truck traffic shall require a minimum of
60 inches for Cat 773 (or equivalent)of Drain Cover Fill placed over the geomembrane and
a minimum of 120 inches for CAT 777 (or equivalent) of Drain Cover Fill placed over the
geomembrane.
5. When placing Drain Cover Fill the maximum acceptable drop height is 3 feet.
6. CONTRACTOR shall operate equipment in a manner that is protective of underlying
geosynthetics. if MANAGER or CERTIFYING ENGINEER suspects the occurrence of
any damage to the underlying geosynthetics, MANAGER will instruct CONTRACTOR
to remove Drain Cover Fill to expose the geosynthetics. CONTRACTOR shall uncover,
repair any observed damage of the underlying geosynthetics, in accordance with the repair
Section 02200 Page 13 of 16 May 9,2012
Earthworks Revision 1