Laserfiche WebLink
<br />File Name Conventiop~ ';fith <br />."'''',,-. v, '" <br />, . ~ I" <br />The following filename extensions for the optional files are as follows: ,.'. . .,' c' <br />. UF UFIL, optional report units, precision file. <br />.BA T Batch file. (There is a generic batch file to run all <br />procedures, refer to section 2.3 [page 13]) <br />.TXT Text comments. <br /> <br />Operations Guide <br /> <br />NOTE: USER CREATED FILES HAVE A TWO CHARACTER EXTENSION, WHILE FILES <br />CREATED BY THE MODULES HAVE A THREE CHARACTER EXTENSION. <br /> <br />The main advantage of using these conventions is consistency. The files are named according <br />to the project, and the filename extensions are easily referenced by their purpose. It also simplifies <br />file management for a project and expedites recovery of archived files for any particular case. <br />The .TXT file is for comments. The intention is that someone else, sometime later, should be <br />able to recover all of the files for a given project/case; look at the text file to see what was done, <br />why, when, by whom; and reproduce the entire study or such parts of it as may be needed. This file <br />is not used by any of the HYDROSS modules and can be in any format you feel is appropriate. <br /> <br />2.2 Module Processing <br />The following modules may be run separately, or by Batch files. <br /> <br />2.2.1 H410 Table Processinl!: This module pre-processes the Tables. <br /> <br />To run H410, you need the following files: <br />TBLS (*.TS ) Table source file. <br /> <br />The program will generate the following files: <br />TBLB (*.TBL) Table File. <br />MSG (*.MSG) Message File. The message file will be appended to <br />any previous message file. <br /> <br />': <br /> <br />The filenames of the input and output file MUST be specified. Either use the following <br />format or the ProjectName option described in paragraph 2.2.8 [page 121. The options may appear <br />in any order. Each the filenames may be up to 63 characters in length, however DOS will not accept <br />all the characters should a full (63 characters) path be specified for each filename; <br /> <br />To run H410 using specified input files, use the following command: <br />H410 S=1BLS T=1BLB <br /> <br />ALWAYS USE H430 AFTER USING H410 AND BEFORE USING H400. <br /> <br />, ! <br />!-..: <br /> <br />March 25, 1991 <br /> <br />HYDROSS 4.1 <br /> <br />Page 9 <br />