FLOOD01455 - Laserfiche WebLink

Home Browse Search

Requests by the CONTRACTOR for survey reference points and bench marks must be made in sufficient time to permit the ENGINEER to accomplish such surveys on normal working days. Work which the CONTRACTOR has done, before reference points and bench marks have been provided, may be rejected. Should the original reference points and bench marks which the ENGINEER provided by obliterated or dislodged by operations which the CONTRACTOR controls, the ENGINEER will replace them and charge the CONTRACTOR for the survey. The cost of these resurveys will be determined by multiplying the hourly equivalent of the salaries and fringe benefits paid to the survey personnel actually involved in the resurvey by the hours expended in doing that resurvey plus material and equipment costs. GC-g Land and Rights-of-Way. Prior to issuance of Notice to Proceed, the OWNER will obtain all land and rights-of-way necessary for carrying out and for the completion of the WORK to be performed pursuant to the CONTRACT DOCUMENTS, un 1 ess otherwi se stated in the SPEC IAL CONTRACT CONDITIONS. The OWNER will provide to the CONTRACTOR information which delineates and describes the lands owned and rights-of-way acquired. The CONTRACTOR shall provide at his own expense and without liability to the OWNER or the ENGINEER any additional land and access hereto that the CONTRACTOR may desire for temporary construction facilities, or for storage of materials. GC-I0 Drawings, Specifications, and Submittals. 10.01 GENERAL. DRAWINGS and SPECIFICATIONS are integral parts of the CONTRACT. These are intended to provide detail s adequate to permit full understandi ng between the CONTRACTOR and the OWNER of work to be performed under the CONTRACT. The Drawi ngs and SPECIFICATIONS are intended to be complimentary and must be interpreted in that sense. Any discrepancies found between the DRAWINGS and SPECIFICATIONS and site conditions or any inconsistencies or ambiguities in the DRAWINGS or SPECIFICATIONS shall be immediately reported to the ENGINEER and/or OWNER in writing, who shall promptly correct such inconsistencies or ambiguities in writing. WORK done by the CONTRACTOR after his discovery of such discrepancies, inconsistencies or ambiguities shall be done at the CONTRACTOR's risk. I f work, a 1 though not descri bed by the d rawi ngs and specifications, appears to be necessary for the successful performance of the CONTRACT and if the necessity for such work can reasonably be implied from the CONTRACT DOCUMENTS, the CONTRACTOR shall perform that work as if it were specified. IV-8 (1667-3/90)