Laserfiche WebLink
6.1.10.3 A Measuring Device or Alternative Measurement Method used to <br /> measure releases from storage. Measurement of releases may also be <br /> made by calibrated release tables. <br /> The combination of 6.1.10.2 and 6.1.10.3, above, shall be considered sufficient by <br /> the Division Engineer to detei mine or calculate evaporation, inflows, and <br /> outflows. <br /> 6.2 Recording Device Functional Standard: <br /> 6.2.1 A Recording Device may be required for any Measuring Device or Alternative <br /> Measurement Methods pursuant to the terms and conditions of a water court <br /> decree, the terms and conditions of a well permit, or as may be reasonably <br /> required by the Division Engineer. <br /> 6.2.2 Where a Recording Device is required, the Recording Device shall be a device <br /> acceptable to the Water Commissioner or Division Engineer that is capable of the <br /> accurate and continuous recording of Flow Rates in accordance with the standards <br /> set forth in Rule 6.1.2, 6.1.3, or 6.1.4 depending on the Flow Rate, at no greater <br /> than 15-minute intervals. <br /> 6.2.3 Where a Recording Device is required, the Recording Device must include a <br /> means to verify on-site that the Recording Device is properly calibrated. <br /> 6.2.4 Where a Recording Device is required, the Recording Device shall not be deemed <br /> complete and acceptable until all equipment and software necessary to download <br /> and process recorded data from the Recording Device is supplied to the Water <br /> Commissioner and/or the Division Engineer by the User. <br /> 6.3 Temporary Measurement Method: <br /> In the instance where an accepted Measuring Device or Alternative Measurement Method is <br /> incapable of accurately measuring flows, the Division Engineer may allow another temporary <br /> Measurement Method until the Measuring Device or Alternative Measurement Method is <br /> repaired, replaced, or restored. <br /> 6.4 Measurement Method Verification: <br /> 6.4.1 If a Measuring Device is properly installed and maintained and has a standard <br /> rating table, an accepted custom rating table, or stage-capacity table, as <br /> applicable, the Division Engineer shall presume that the Measuring Device is <br /> accurate, and no verification will be required. <br /> 8 <br />