Laserfiche WebLink
Method shall be designed to meet an accuracy standard approved by the Division <br /> Engineer throughout the full range of anticipated flows. <br /> 6.1.5 A Measuring Device or Alternative Measurement Method shall be located within <br /> reasonable proximity of the Diversion Structure or Other Structure, as determined <br /> by the Water Commissioner, to enable the Water Commissioner to observe the <br /> effect of any Headgate adjustments or other operational adjustments. <br /> 6.1.6 A Measuring Device or Alternative Measurement Method shall be properly <br /> installed, and, if applicable, calibrated to engineering specifications. <br /> 6.1.7 A Measuring Device or Alternative Measurement Method shall be maintained by <br /> the User in a condition that provides accurate measurement throughout the full <br /> anticipated range of Flow Rate or volume of water diverted, stored in a Reservoir, <br /> released from a Reservoir, or otherwise delivered for any purpose. <br /> 6.1.8 A Measuring Device or Alternative Measurement Method shall not be deemed <br /> complete and acceptable until such time that the proper rating table for the <br /> Measuring Device or Alternative Measurement Method, or stage-capacity table, <br /> as applicable, has been made available to the Water Commissioner, unless such <br /> rating table is for a standard flume, weir, or meter and is otherwise available to <br /> the Water Commissioner. <br /> 6.1.9 Off-Stream Reservoirs require two of the following, as approved by the Water <br /> Commissioner or Division Engineer: <br /> 6.1.9.1 A Measuring Device or Alternative Measurement Method at the point <br /> of Diversion of the structure used to deliver water to a Reservoir; <br /> 6.1.9.2 A Measuring Device or Alternative Measurement Method used to <br /> measure the volume of water in storage; or <br /> 6.1.9.3 A Measuring Device or Alternative Measurement Method used to <br /> measure releases. Measurement of releases may also be made by <br /> calibrated release tables, gaging, or calculation of the change in storage. <br /> 6.1.10 On-Stream Reservoirs require: <br /> 6.1.10.1 The installation of an outlet or other structure capable of releasing all <br /> out-of-priority inflows; <br /> 6.1.10.2 A Measuring Device or Alternative Measurement Method used to <br /> measure the volume of water in storage; and <br /> 7 <br />