2013-02-20_REPORT - M1980244 - Laserfiche WebLink

Home Browse Search

CC &V PROJECT NO. SC -07 -002 January 4, 2013 2 TRAFFIC CONTROL PLAN - GENERAL On all 2 -lane portions of highway, the Contractor shall maintain a minimum of one lane open to traffic at all times, unless otherwise approved by the Engineer. During the resurfacing work, only one lane may be closed to traffic at any time unless approved by the Engineer. The Contractor shall not have cumulative delays to the traveling public through all construction zones that would exceed 15 minutes in each direction. If delays exceed the times indicated as determined by the Engineer, the Contractor will be asked to remove their equipment and resume traffic control until traffic is resumed to a reasonable level. The Contractor shall direct oversized vehicles around the work zone. Wide -loads shall be restricted when work required the travel lane to be less than 14 -feet wide. Access to /from Approach Roads. Unless otherwise included in the plans, or as directed by the Engineer, the Contractor shall maintain access to and from each approach road. One lane of traffic shall be maintained at all times. During the work one lane of traffic will be maintained during day with flaggers. The Contractor may elect to work multiple shifts in order to meet the time constrains required for this project. All flagging stations used at night shall be adequately illuminated in accordance with the MUTCD. Adequate illuminations of flagging stations shall include the use of light plans whenever other sources of adequate lighting are not available. Adequate illumination shall be as approves or determined by the Engineer. The Contractor shall provide necessary lighting during night construction. Storage of Contractor's equipment as approved by the Engineer shall be limited to the following: (1) At least 30 feet beyond the edge of the pavement. (2) Behind protected barrier if less than 30 feet. Any signs, delineators, or other devices damaged due to Contractor operations shall be replaced in kind or repaired by the Contractor at no cost to project. The Contractor, prior to starting work, shall make an inventory of existing signs and submit the inventory to the Engineer. Fines double signs shall be placed according to CDOT Standard Special Provisions. The Contractor shall limit fines double signs to activities where and when workers are present on the roadway. All costs incidental to the foregoing requirements shall be included in the original contract prices for the project. 17