Laserfiche WebLink
Each well will be cased and consist of an outer hanging injection string and a center <br /> production casing. Solution mining will involve injection of up to 300 to 350OF water down <br /> the outer hanging injection string and flow-back to the surface with the pregnant nahcolite <br /> brine through the center production tubing. From time to time the flow direction may be <br /> reversed. The surface plant equipment will crystallize the nahcolite, recover most of the <br /> heat from the brine solution, and reinject the barren brine/water after reheating the injection <br /> fluid up to 300 to 350°F. <br /> The injection of hot water serves two purposes: <br /> 1. The hot water increases the dissolution rate of the nahcolite; and <br /> 2. The hot water causes the oil shale in which the nahcolite is distributed to rubblize which <br /> allows access to additional nahcolite ore. <br /> Based on rock mechanics testing and analysis, Hardy and Goodrich (July, 1996) determined <br /> that using this method of solution mining will result in good roof stability for cavern diameters <br /> up to 225 feet. <br /> 4.2. SOLUTION MINING <br /> The proposed solution mining technique is similar to that demonstrated by the Shell Oil <br /> Company in the Piceance Creek Basin in the early 1970's. The technique has been revised <br /> and reengineered based on Shell's pilot facility experience (Prats et al, 1977), the <br /> experience of Denison Resources Ltd. Of Brisbane, Australia, and the knowledge and <br /> experience of Kavernen Bau - Und Betriebs - GMBH (KBB) of Hanover, West Germany and <br /> PB-KBB of Houston, Texas. The primary solution mining technique is to initially drill a single <br /> vertical well. A hot, dilute (7 percent NaHCO3) bicarbonate solution will be injected into the <br /> cavity; allowed to dissolve the nahcolite under controlled conditions of temperature, <br /> pressure and flow rate, and then extracted as a nearly saturated solution. Once the nearly <br /> saturated solution is brought to the surface, it may be filtered to remove particulate <br /> contamination. The solution will be cooled and the sodium bicarbonate crystallized. The <br /> solid crystals will be removed from the mother liquor, dried and screened into various size <br /> grades. A more detailed process description is included in Section 4.6 Nahcolite Surface <br /> Processing Facilities. The general solution mining operation is shown in Figure 4-2. <br /> The nahcolite that will be solution mined is located in the lower part of the Saline zone. This <br /> zone contains disseminated nahcolite nodules, aggregate, crystals and beds of nahcolite <br /> G:1LMM78545.00ZMinePlan%MINEPLAN.DOC 4-3 <br />