2011-01-03_GENERAL DOCUMENTS - P2008043 ‎(3)‎

• Permit No: P2008043
• IBM Index Class Name: GENERAL DOCUMENTS
• Doc Date: 1/3/2011
• Doc Name: Petition For Review Of UIC Permit- 2.
• From: Coloradoans Against Resources Destruction
• To: EPA
• Permit Index Doc Type: Gen. Correspondence
• Media Type: D
• Archive: No

PART II. SPECIFIC PERMIT CONDITIONS
A. GENERAL
Copies of all reports and notifications required by this permit shall be signed and certified
in accordance with the requirements under Part III, Section E.9 of this permit and shall be
submitted to the EPA:
U.S. Environmental Protection Agency - Region 8
Shallow Well Compliance Lead, Mailcode: 8ENF-UFO
1595 Wynkoop Street
Denver, CO 80202-2699
The EPA permit number the UIC Program Director (hereafter referred to as the
"Director") has assigned to this permit is C051237-08412. All correspondence should reference
the site name and address and include the EPA permit number.
B. SHALLOW INJECTION WELL CONSTRUCTION
1. Construction Requirements. The method for construction of any injection well
shall not allow the movement of a fluid containing any contaminant into any underground source
of drinking water (USDW), if the presence of that contaminant may cause a violation of the
primary drinking water standards under 40 CFR Part 141, other health-based standards, or may
otherwise adversely affect the health of persons. The construction design for the proposed
injection is shown in Figure 2 of Appendix A of this permit. Well construction shall meet the
specifications shown in Figure 2. Mechanical integrity testing shall be performed on the well and
results submitted to the Director before commencing injection.
2. Proposed Changes. The permittee shall give advance notice to the Director as
soon as possible and no later than thirty (30) days before any planned physical alterations or
additions to the permitted injection well(s) or the injection system. Any alterations to the
injection system shall meet all conditions as set forth in this permit. An alteration or addition
shall be considered any work performed that affects the quantity or quality of the fluid being
injected or changes in the design of the injection system from the construction design diagram in
Appendix A of this permit.
After approval by the Director, the permittee shall provide plans, as-built schematics,
sketches, or other test data, to EPA within sixty (60) days of completion of the alteration or
addition that took place.
C. CORRECTIVE ACTION
No corrective action is required prior to issuance of this permit.
Powertech (USA), Incorporated
Final UIC Class V Permit No. C051237-08412
Page 2 of 14