2009-07-15_REVISION - M1980244 ‎(39)‎

• Permit No: M1980244
• IBM Index Class Name: REVISION
• Doc Date: 7/15/2009
• Doc Name: LOB Relocate- Appendix D- Tech Specs 2
• From: CC&V
• To: DRMS
• Type & Sequence: AM9
• Media Type: D
• Archive: No

amec'?
•
e. Roll dimensions
3. CONTRACTOR shall ensure that geotextile rolls are properly loaded and secured to
prevent damage during transit.
4. CONTRACTOR shall protect geotextile from excessive heat, cold, puncture, cutting, or
other damaging or deleterious conditions.
5. CONTRACTOR shall ensure personnel responsible for loading, transport, and unloading
of are familiar with handling and transport constraints imposed by MANUFACTURER.
B. Acceptance at Site
1. CQA Monitor shall perform inventory and surface inspection for defects and damage of all
geotextile rolls upon delivery.
2. CONTRACTOR shall unroll and inspect any geotextile roll that may be damaged below
surface.
3. CONTRACTOR shall repair damage resulting from handling and transport of geotextile at
no cost to CC&V. If irreparable, in the opinion of CERTIFYING ENGINEER, damaged
materials shall be replaced at no cost to CC&V.
C. Storage and Protection
•
MANAGER will provide on-site storage area for geotextile rolls from time of delivery until
installation.
2. The storage of the materials is the responsibility of CONTRACTOR from the time the
materials are manufactured until the time the completed installation is accepted.
CONTRACTOR is responsible for preparing the storage location and. for the protection of
the material from the elements (e.g. ultraviolet light, moisture, temperature, etc.).
3.
4.
5.
PART 2: PRODUCTS
2.01 MATERIALS
After CONTRACTOR has removed material from storage area, protect geotextile from
puncture, dirt, groundwater, moisture, mud, mechanical abrasion, excessive heat, ultraviolet
light exposure, and other sources of damage.
Geotextile shall be supplied in rolls wrapped in relatively impermeable and opaque
protective covers, with straps for unloading.
CONTRACTOR shall preserve integrity and readability of the geotextile roll labels, and
store such that MANAGER and CERTIFYING ENGINEER have access to the package
slips or roll labels for each roll to verify roll acceptance.
A. Twelve-ounce Non-Woven Needle Punched Geotextile:

Geotextile shall be comprised of polyester or polypropylene fibers.
Section 02777 Page 3 of 5 September 3, 2008
Geotextile Revision 1
SAProjects\1125 CC&V Phase 5 VLF\I - Tech Specs\Arequa IFC Specs\02777.r1.doc