Laserfiche WebLink
• 3.5.3 Post Mininq Contours <br />The projected postmining topography of Trapper Mine is shown on Map M12, Postmining Topography. <br />This map depicts the expected configuration of the permit area at the end of 2014, except for temporarily <br />abandoned D/E pit that shows postmining topography after it is filled with utility ash near the end of mine <br />life. The postmining topography map was developed using actual topography from aerial surveys in <br />October 2006, along with engineering estimates of material movement from 2008 through .2012 Map M- <br />14A includes a series of cross-sections that provide a comparison of pre and post mining topography in <br />the active mining are for the current permit term (2008-2012). <br />Postmining topography cannot be predicted exactly, however, the best estimate given today's technology <br />is presented. Map M12 is, therefore, an approximation of the recontouring limits with a representation of <br />the shape of the topography that will most likely be produced. However, by March 15th each year of the <br />permit term, Trapper will submit to the Division a map showing actual postmining topography for the <br />previous year. Appendix W will contain each year map. <br />As production fluctuates to reflect changes in economic and natural conditions, the areas requiring <br />regrading may change to a limited extent Lengthening or shortening of various cuts may occur as they <br />are more precisely designed, and thus cause some deviation from the map as presented. Cut lengths <br />• may be affected as a result of better or worse economic conditions which affect the economic stripping <br />limit, or as a result of differences between inferred coal oxidation limits from existing drill data versus the <br />actual limits encountered when mined. <br />If changes in cut lengths occur, the locations of the pits as of December, 2012, may also be affected as <br />the progression of the pits is a function of their lengths. The pit locations may also be affected by several <br />other factors such as changes in the characteristics of the overburden and interburden which in turn affect <br />digging rates or by changes in scheduled digging times resulting from labor or equipment problems. <br />These influences could cause an increase or decrease in the areas requiring regrading as compared to <br />those shown on Map M12. Regrading areas depicted on Map M12, Postmining Topography, and Map <br />M10 series, represent regrading under maximum production. <br />As explained in section 3.1.4.1, permanent fills resulting from K-pit truck/excavator operations are <br />envisioned for Horse Gulch and the Buttress area. These fills will result in raised topography in the <br />affected areas. The fill locations are shown on Map M10A. The postmining configuration is shown on Map <br />M12. Final geotechnical designs for the Horse Gulch fill have been submitted and are included in <br />Appendix T. A description of each fill is shown below. <br />Horse Gulch Fill <br />Mining of the K-Pit with a truck and excavator (T/E) fleet will require the use of a head of hollow fill capable <br />of storing approximately 24.6mm BCY of excess spoil. The fill is necessary to ensure the safety of men <br />and equipment during mining operations. Spoil placed upslope of the active TIE fleet could have potential <br />• to fail, moving downslope onto the T/E or coal loading operations. <br />3-40 <br />Revision: _ P 2- 1, <br />Approved: --