Laserfiche WebLink
THE INFORMATION ON THIS PAGE DOES NOT NEED TO BE HELD CONFIDENTIAL <br /> Exhibit C-AMSO,LLC Notice of Intent Supplemental Information <br /> • <br /> T-1 See Figure C.6 in this sl'ection <br /> _ ( g ) <br /> Illite Test Hole 1 <br /> • Drill a 24"diameter hole a minimum of 20 feet with at least 5 feet into competent <br /> bedrock. Historically, surface casing holes have been 40 to 60 feet deep. <br /> (Mud,Air or Air/Foam) <br /> • Run 20",94#J-55 Surface Casing. <br /> • Cement with"Neat Cement"to surface. <br /> • Rig up diverter and wait on cement a minimum of 4 hours. <br /> • Drill out from surface casing with 19"diameter bit_ Drill to a depth to where the <br /> down hole survey tools will not be influenced by the steel surface casing. <br /> • Trip out of the hole and put on a mud motor with 19"bit_ Utilize the motor and <br /> surveys to parallel the alignment created by TM-1. Complete directional surveys <br /> every 40 feet. <br /> • Directional drill the 19"hole to 2050 feet(top of the RI). <br /> • • Condition the hole and run 16", 75#,K-55 casing. <br /> • Cement with Type I or II Portland cement with 2%bentonite to surface. <br /> • Wait on cement 12 hours. <br /> • Drill out of casing with a 14" bit to a Total Depth of—2270' <br /> • Trip out of the hole and run a gyro directional survey to surface. <br /> • Rig down and move to HB-1 hole. <br /> • <br /> 16 <br />