PERMFILE103529 - Laserfiche WebLink

Home Browse Search

~ Exhibit A ~/In Attached to and made s pan ofthat certain Agreement to Mine Within 200 Fe<t of a Men-Made ~~~ Stucmre made between Asphalt Paving Company, and Kart-McGee GaNering LLC General Guidelines for Design and Construction Activities On or Near Kerr-McGee Gathering LLC and Kerr -McGee Rocky Mountain Corporation Pipelines and Related Facilities AC Eledricel lines must be installed In conduit and properly insulated. • On all foreign pipelines, O0T aDProved pipeline markers shall ba installetl so as to Indicate the route of the foreign pipeline across the KMG ROW. • No power poles, light standards, etc. shall be installed in the KMG easement without written approval Dy KMG. • KMG installs above ground appurtenances at venous locations that are used in the operation of its fadliges. Ken McGee will install protedive enGosures at the above ground appurtenances to prated them from outside damage. The design and placement of these above ground appurtenances end protedive enGosures is done at KMG's sole discretion, and may exceed any regulatory requirements. Construction • If KMG will be relocating KMG facilities for any entity, grading in the new KMG ROW shall be +/- a inches before KMG will mobilize to complete Ne reloce0on. Final cover after the cempletion of the project will not be less than 45' nor more than 72'. All cover that exceeds 72' or lass than 48' will be approved in writing by KMG. Cover during all consWdion activities will NEVER be less than 36' unless approved in writing and a KMG representative is on site during Ne tlme cover is reduced. • The entity requesting reloa5on shall survey top of pipe after installation but before backfill to detennina proper final elevation of KMG taGlities. The entity requesting relocation ie solety responsible for the foal depth of cover over the relocated KMG facility. Any deviation from rover requirements as outlined above will be cemeded at the sole expense of the entity requesting reloa5on. • Contractors shall be advised of KMG's requirements and be centraqually obligated to cempty. • The centinuetl integrity of KMG's pipelines and the safely of all individuals in the area of proposetl work near KMG's facilities are o(the utmost Importance. Therefore, centradar must meet with KMG representatives poor to consuudion to provide antl receive notification lisangs for appropriate area operations and emergenry personnel. KMG's onalte reprecanradve will require discontlnuatlon of any work that, In his or her opinion, endangers the operetlons or safety of personnel, pipelines or fecilitlee. • The Contractor must expose all KMG pipelines prior to crweing to determine the exact alignment end depth of the lines. A KMG representatlve must be presets. • The use of probing rods (or pipeline loceting shall be padormed by KMG representatives only, to prevent unnecessary damage to the pipeline coating. A KMG representa5ve shall do all line locating. • Notification shall be given to KMG at least 72 hours before stars of WnsWCtion. A schedule of adivitles for the durafion of the project must be made available al that lime to facilitate the scheduling of KMG's work site representative. Any Contredor schedule changes shall be provided to KMG immediately. • Heavy equipment will not be allowed to operate directly over KMG pipelines or in KMG ROW unless written approval is obtained kom KMG. Heavy equipment shag onty De agowed tc cross KMG pipelnes et locations designated by KMG. Haul roads will De consWMed et all crossings. The haul roads will be censWcted using lightweight equipment. The exisfing depth of cover over the pipeline must be verified. Cover will be added such that a total of 8' of fiA exists over the pipeline and extends a minimum of 10' on each side of the pipeline. Depth of rover will then taper as required far equipment access. Steel plates may be used for load dissipation only H approved in writing by KMG. • Contredor shall comply with all preceutionary measures required by KMG,et it's sole discre5on to prated its pipelines. When inGement weather exists, provisions must be made to compensate for soil tlisplacement due to subsidence of tires. • Excavating or grading which might result in erosion or which ceultl render the KMG ROW inaaessible shall not be permitted unless the cenuedor agrees to restore Ne area to its original centlitlon antl provide protection to KMG's facility. At no lime will cover De reduced to lass than 35' without written approval by KMG and a KMG representatve on site. • A KMG representative shall be on-site to monitor any censtruclien acOvities withintwenty-five (25) feet of a KMG pipeline or aboveground eppunenance. The centredor shall not work within Nis d(stance without a KMG representative being on site. Contractor shall use extreme caution and take any appropriate measures to protect KMG facilities. • Ripping is only allowed when the position of the pipe is known antl not within ten (10) feet of KMG fadlity. KMG personnel must be present. • Temporary support of any exposed KMG pipeline by Conbadw may be necessary if required by KMG's on-ate representable. BaGrfill below the exposed lines and 12' above the lines shall be replaced with sand or other seledetl material as approved by KMG's on-site representative and thoroughly compacted In 12' lifts to 95% of standard proctor dry density minimum or as approved by KMG.'s on-site representative. This is to etlequately protect against stresses that may ba roused by the settling of the pipeline. • No blasting shall be allowed within 100D feet of KMG's taGlities unless blasting no5firation is given to KMG Inducting complete Blasting Plan Data. Apra-blast meeting shall be conducted by the organization responsible for blasting. KMG shall be indemnifietl and held harmless from any loss, wst of liability for personal injuries receiveQ tleath ceusetl or properly damage auHered or sustained by any person resulting from any blasting opeatlons undertaken within 500 feet of Page 2 of 3 Revision 3!01/2004