Laserfiche WebLink
<br />IJ <br />ground surface for installation of the geomembrane V <br />liner. <br />2. All sharp rocks, large stones, roots, vegetation, <br />and other foreign material will be removed from the f <br />interior of the tailings impoundment area. <br />3. Any remaining surface irregularities will be <br />smoothed out, and a layer of compacted decomposed <br />granite will be placed on the bottom and sides of the ~ <br />tailings impoundment area. <br />4. An anchor trench 6 inches wide by 12 inches deep <br />will be dug with a backhoe around the inner perimeter <br />of the tailings dam to hold the edge of the geomembrane <br />liner. This trench will be at least 1 foot from the <br />interior slope of the tailings impoundment area. ~c <br />t~\_ ~y <br />'S. A polyvinyl chloride (PVC) plastic liner with a ~'`P~~~ <br />minimum thickness of 20 mils will be placed over the ~~" <br />prepared ground surface in a manner that assures a <br />minimum of handling. <br />6. The geomembrane lining will be closely fitted and f <br />sealed around inlets, outlets, and other projections <br />through the lining. <br />7. The geomembrane liner will be sealed to the <br />vertical sections of the water decantation pipe with <br />separate patches of liner having a minimum width of 8 <br />inches around the lap hole. The hole in the patches / <br />will be smaller than the diameter of the vertical <br />sections of the pipe and will be stretched over the <br />pipe to form a flange. <br />8. Any portion of the geomembrane lining that is ~ <br />damaged during installation will be removed or repaired <br />by using an additional piece of lining material. <br />9. Lap joints will be used to seal the panels of PVC <br />together in the field. Lap joints will be formed by <br />overlapping the edges of the PVC panels a minimum of 2 <br />inches . ~~ ~ ~- <br />10. The contact surfaces of the lap joints will be ~u <br />wiped clean to remove all dirt, dust, or other foreign / '/~~, <br />materials. A 1/2 inch wide bead of cold-applied vinyl <br />to vinyl bonding adhesive will be applied to the <br />contact surfaces of the joint areas before the two <br />surfaces are pressed together and any wrinkles are <br />smoothed out. <br />11. Sand bags will be used to keep the geomembrane <br />liner in position during windy conditions prior to ~ <br />-2- <br />