_REVISION - M1980244 ‎(30)‎

• Permit No: M1980244
• IBM Index Class Name: Revision
• Doc Name: Appendix E
• From: Cripple Creek & Victor Gold
• To: DMG
• Type & Sequence: AM8
• Media Type: D
• Archive: No

3. CONTRACTOR shalt repair damage resulting from handling and transport of
geomembranes at no additional cost to CC&V. If irrepazable, in the opinion of
• CERTIFYING ENGINEER, damaged materials shall be replaced at no additional
cost to CC&V.
C. Storage and Protection
MANAGER will provide area for on-site Stomge of the geomembrane rolls from time
of delivery until installation.
2. The storage and handling of the materials is the responsibility of CONTRACTOR
from the time the materials are manufactured until the time the completed installation is
accepted. CONTRACTOR is responsible for preparing the storage location and for
the protection of the materials from the elements (e.g. ultraviolet light, moisture,
temperature, etc.).
3. After CONTRACTOR has removed material from storage, CONTRACTOR shall
protect geomembrane from puncture, dirt, grease, water, moisture, mud, mechanical
abrasion, excessive heat and other sources of damage.
4. CONTRACTOR shall preserve integrity and readability of the geomembrane roll
labels, and store the rolls such that MANAGER and CERTIFYING ENGINEER
have access to the package slips or roll labels for each roll to verify roll acceptance.
5. The rolls shall be stored on a prepared surface (not wooden pallets) and should not be
stacked more than two rolls high.
1.05 SITE CONDITIONS:
A. Geomembrane Deployment
t. Do not proceed with deployment at an ambient temperature below 14° F or above
100° F unless otherwise authorized, in writing, by MANAGER, DESIGN
ENGINEER and CERTIFYING ENGINEER. Temperature monitoring shall be
perforated by the CQA Monitor.
2. Do not deploy during precipitation, in the presence of excessive moisture (e.g. fog,
dew), in an area of ponded water, or in the presence of excessive winds.
3. Do not undertake deployment if weather conditions will preclude material seaming on
same day as deployment.
B. Seaming
1. Normal Weather Conditions
Normal seaming procedures may take place if the following weather conditions exist:
a. Ambient temperature between 35° F and 100° F.
b. Dry conditions, i.e., no precipitation or other excessive moisture, such as fog
or dew.
• c. No excessive winds.
2. Adverse Weather Conditions
Section 02776 Page 6 of 20 October 25, 2000
Geomembrane Golder A55ociate5 Revision 8
D ~PHASEI V PSSA CERT~APPENDIC~SWPPEWIX E TEGt¢JIC.1L SP[CRtCATIONSl993-2099~'_]]bIRB.DOG