_REVISION - M1980244 ‎(30)‎

• Permit No: M1980244
• IBM Index Class Name: Revision
• Doc Name: Appendix E
• From: Cripple Creek & Victor Gold
• To: DMG
• Type & Sequence: AM8
• Media Type: D
• Archive: No

C. Submittals By CONTRACTOR to MANAGER during the course of the work.
1. Daily reports detailing arrival and departure times, the personnel present on-site, the
progress of the Work, the amval of materials, daily square footage deployed and
seamed, daily square footage of geomembrane approved by the CQA Monitor and any
problems encountered.
2. Subgrade surface acceptance certificates for each area to be covered by the lining
system, signed by CONTRACTOR.
D. Without limiting the provisions of the Contract, the CONTRACTOR shall warrant the Work to
MANAGER in accordance with the following:
1. The geomembrane supplied is suitable for the environmental conditions at the site and
the service conditions as described in this SPECIFICATION.
2. The geomembrane supplied meets or exceeds al] published SPECIFICATIONS as
referenced by the SPECIFICATION.
3. The geomembrane are free of defects in materials and workmanship.
4. The CONTRACTOR shall repair or replace all defects in the material detected on-site,
including uncovering and recovering the work, in compliance with the
SPECIFICATIONS at no additional cost to CC&V.
5. The CONTRACTOR shall repair any detected leaks in any seams (Manufactured or
field joined), including uncovering and recovering the work, in compliance with the
SPECIFICATIONS at no additional cost to CC&V.
. 1.03 QUALITY ASSURANCE:
A. Manufacturing Qualifications
The MANUFACTURER(S) shall have experience in the manufacture of the type of
geomembrane that is being installed at the Cresson Project totaling at least five
completed facilities totaling a minimum of 5,000,000 square feet between all five
facilities.
2. The MANUFACTURER shall provide sufficient production and qualified personnel to
meet the demands of the work and shall have an internal quality control program for its
product.
3. The MANUFACTURER shall permit MANAGER, DESIGN ENGINEER, and/or
CERTIFYING ENGINEER or they authorized representative to visit the
manufacturing plant.
B. Geomembrane Installation Qualifications (INSTALLER)
1. INSTALLER shall be the MANUFACTURER or an approved CONTRACTOR
trained and licensed to install the MANUFACTURER'S geomembrane.
2. Installation shall be performed under the constant direction of single Installation
Superintendent who shall remain on-site and be responsible, throughout the
geomembrane installation, for geomembrane layout, seaming, patching, testing repairs,
. and all other activities by INSTALLER.
Section 02776 Page 3 of 20 October 25, 2000
Geomembrane Golder A55ociate5 Revision 8
D ~PHASEIV p58A CERTAPPENDIC~SNPPENOIX E rECHNICAL SPECIEICATION51933-509902]]61RB.000