REV88104 - Laserfiche WebLink

Home Browse Search

5. CONTRACTOR shall preserve integrity and readability of the geonet roll labels, and store such that CQA Monitor shall have access to the package slips or roll labels for each roll to verify roll acceptance. PART 2: PRODUCTS 2.01 MATERIALS A. The material to be used on the project shall comprise HDPE geonet drainage material. B. Geonet shall meet or exceed the minimum properties listed in Table 02275-1, at the eod of this Section. 3.01 INSTALLATION A. The geonet shall be installed in accordance with the Manufacturer's recommended procedures. B. The CQA Monitor shall verify that all geonet rolls and underlying layers are free from deleterious material or debris prior to the geonet deployment. Dirt entrapped in the geonet following deployment shall be cleaned or affected geonet removed and replaced prior to placement of successive layers. B. On side-slopes, the geonet shall be secured in the anchor trench and shall be deployed parallel to the dip of the slope. The geonet panels shall be positioned to minimize wrinkles. • D. The CONTRACTOR is responsible for anchoring exposed geonet to protect against wind damage until subsequent layers are placed. E. The geonet shall not be welded to the geomembrane unless speciFied otherwise. F. The geonet shall only be cut utilizing methods and tools (i.e., a hooked utility blade) which will not damage the geonet or other previous WORK. G. The geonet shall be overlapped a minimum of six (6) inches between adjacent panels and shall be fastened in accordance with manufacturer's recommendations or as approved by MANAGER. H. in general, butt-seams will only be allowed on grades less than fifteen percent (15%). Butt- seams shall be overlapped a tninimum of two (2) feet and be secured in accordance with manufacturer's recommendations or as approved by CERTIFYING ENGINEER. The CONTRACTOR shall be responsible for Field handling, storing, deploying, seaming or joining, temporary restraining (against wind), anchoring, and other aspects of geonet installation. L. The CONTRACTOR shall accept and retain full responsibility for all materials and installation and shall be Geld responsible for any defects in the completed systems. 3.02 REPAD2S A. Any defects observed in the geonet shall be brought to the attention of the CERTIFYING ENGINEER. Section 02275 Page 4 of 7 February I5, 2000 Geonet Golder Associates Revision 0 1:\99\7099\i099SPEC. DDC