2003-03-11_REVISION - M1998013

• Permit No: M1998013
• IBM Index Class Name: Revision
• Doc Date: 3/11/2003
• Doc Name: Board Order
• From: MLRB
• To: Hall-Irwin Corporation
• Type & Sequence: AM1
• Media Type: D
• Archive: No

Based on the foregoing findings of fact and conclusions of law, the Board orders that
Hall-Irwin Corporation's application to amend Permit No. M-1998-013 is hereby
approved as AM-01, with the following conditions:
A reportable spill is a spill of any toxic or hazardous substance (including spills of
petroleum products) within the mined land permit area reportable to any Division
of the Colorado Department of Public Health and the Environment, the National
Response Center, the Colorado Emergency Planning Commission, any local
Emergency Planning Commission, local Emergency Planning Committee, or the
State Oil Inspector. The Mine Operator shall notify the Division of Minerals and
Geology (DMG) of a reportable spill within the mined land permit area using the
same timeframe required by the permit, license, notice, statute, rule or regulation
governing the reporting of the spill to the other appropriate agency. Notice of a
reportable spill shall be FAXed to: Minerals Program Supervisor, Division of
Minerals and Geology, FAX [phone]. The FAX shall include acall-back
number of a responsible company official for DMG staff to use a contact.
2. The Applicant shall provide an updated proof of Legal Right of Entry, to the
satisfaction of the Division, prior to the Applicant implementing the modifications
requested in the Amendment Application.
3. If the Operator intends at some point to request the 20 percent bonding option for
slurry wall installation, the following minor changes must be incorporated into the
slurry wall specifications. (The numbering system is taken from the "Draft
Technical Specifications for the Construction of the Shores Resource Slurry
Wall," dated January 2003).
a. Item 1.01 of section 01010 of division 1 of the specifications should be
changed to include units (linear feet) for the "20,000 of slurry wall" to be
installed.
b. Item 1.02 of section 01300 of division 1 of the specifications should be
changed to include units (centimeters per second) for the maximum
permeability of the soil-bentonite backfill.
c. In Table 1 included with the specifications, change the specified value for
sand content in the slurry to state "sand content less than 20 percent by
volume."
4. Hall-Irwin Corporation shall submit a map to the Division that identifies the
buffer zone specified in the parties' surface use agreement for the Kerr-McGee oil
and gas well identified as KM BLCS-lA.
DATED this // day of `/"1'J ~~J , 2003.