2004-10-18_REVISION - M1980244 (2)

Home Browse Search

Hancor, Inc. Drainage Handbook RANCOR SURE-LpECPD F477 p(PE SPEGIFICATIONS Specifications • 1-6 Scope This specification tlescrlbes 4 through 60-inch (100 to 1500 mm) Hancor Sure-Lok F477 pipe for use in non- pressure drainage applications. Pipe Rsqulrementa Sure-Lek F477 pipe shall have a smooth infector and annular ~cterior corrugations. • 4- tnroughl0-loch (100 to 250mm) shall meet AASHTO M252, Type S. • 12- through 4&inch (300 to 1200 mm) shall moot AASHTO M294, Type S. • 60-inch (1500 mm) shall meet AASHTO MP7, • Monolog's "n" value for use in design shall he 0.010 to 0.012. Joint Periormanee Pipe shall be joined with the Sure•Lok (bell-and-spigot) joint meethg AASH70 M252, AASHTO M294, or MP7. Tha jolrlt shall be sift tight and non-rated watertight Sift tightjoints shall meet laboratory test per ASTM D 3212 except that the joint be tasted using 2.0 psi (14kpa). Gaskets shall be made of paiylsOprene meeting the requirements of ASTM F477 with the addition that the gaskets shall not have any visible crar~dng when tested accard'mg to ASTM D1149 agar 72 hour exposure in 50 PPHM ozone of 104° F (40° C). Gaskets shall be installed by the pipe manufacturer and covered with a removable wrap !o enauro the gasket f>5 free from debris, A joint lubricant supplied by the manufacturer shall be used on 4he gasket and bell during assembly. Fittings Fittings shall conform to AASHTO M252, AASIi"I'O M294, or AASHTO MP7. Fabricated fittings, where accessible, shall be welded an the interior and exterior at all jiJnationa. • Material Properties Pipe and fitting material shall be high density polyethylene meeting ASTM D3350 minimum cell dassificatlon ~ 32A420C for 4 through 10-inch (100 to 250nsn) diameters or 3354000 par i2-through 60-inc=h {300 to 1500mm) diameters. 'The 12-through 60-Inch {300 to 1500mm) pipe material shall be Hancor Resin 8 ~'" which is a slow uaok resistant material evaluated using the aingln point notched constant tensile load (SP-NE'I'L) test Average SP-NCTL test spedmens must exceed 24 hrs, with no test insult less than 17 hrs. Quality Assurance AS requested, all corrugated polyethylene pipe meeting or exteeding AASTHO M294 or MP7 shall only be provided by manufactures Ilsied by the Plastics Ptpe Institute (PPI) as having met the roqulrements of the PPI sponsored third-part' cerNtication program. All AASHTO M2g4 and MP7 pipe shall be dearly marked with a certification program manic or logo mpresanting the supplied pipe Is In compliance with all applicable standards. (p Fronton, Ina. April, 2003 Inatallatlon ' Inatallatien shall be In acwrdance with ASTM p2321 with the exception that minimum cover in traff~aked aroas for 4 through 48-inch (100 to 1200 mm) dlameir?rs shag be one-foot (0.3 m) and for 60aneh (1500 mm) diameters shalt be 1.5ft {0.5 mj.