REV10417 - Laserfiche WebLink

Home Browse Search

information be provided and certified to demonstrate compliance within the permit. In order to demonstrate compliance with Rule 4.05.6(3)(c) please include details of the dewatering device. On Pond MB-1 diagram, it is indicated that Merrick drawings C-012, C-013 and C-014 may contain those data, but those do not accompany the MB-1 diagram. The orientation of the drain pipe inlet detail needs to be added, as do details of the baffle and bypass. "there is no description of the nonclogging element of the device. As no profile or description of the elevation of the sediment storage level is provided, a demonstration cannot be made that the dewatering device is not located at a lower elevation. Regarding the Pond MB-4 diagram, only the size and inlet elevation of the dewatering device is indicated. No details of direction, outfall, bends, or other features are shown. There is no information regarding the nonclogging element of the device. As no profile or description of the elevation of the sediment storage level is provided, a demonstration cannot be made that the dewatering device is not located at a lower elevation. The Division requests that the missing information be added to the as-built and certified. 4. The as-built should show the dimensions of the spillway systems so that an operation demonstration can be developed. Barriers to piping should be shown. On the MB-l diagram, the emergency spillway may be described on Merrick drawings C-012 and C-015 and the primary spillway on Merrick drawings C-012, C-013, and C-014. Barriers to piping are not shown, if applicable. On the MB-4 diagram, no dimensions are shown other than the diameter of the primary spillway and the invert elevation of the emergency spillway. The grade, width, slopes, and any protective armor of the emergency spillway should be shown. The configuration and length of theprimary spillway should be shown. Piping barriers should be shown if applicable. 5. To demonstrate compliance with Rule 4.05.6(4) for the primary and emergency spillway, the as-built should demonstrate the 1-foot separation required. For Pond MB-I, the drawing indicates, again, that some of this information at least is on Merrick drawings which do not accompany the as-built. For Pond MB-4, the included information demonstrates non-compliance with this rule as a separation of only 0.6 feet is indicated. 6. To demonstrate compliance within the permit to Rule 4.05.6(1 l)(f), the embankment in- slopes and out-slopes should be shown on the as-built diagrams. These aze not indicated on the diagram for either Pond MB-1 or MB-4.