HYDRO30939 - Laserfiche WebLink

Home Browse Search

PARTI Page 7 Permit No. COG-500000 B. EFFLUENT LIMITATIONS AND CONDITIONS -PROCESS WATER DISCHARGE Effluent Parameter Measurement Freouency d/ g/ Sample Type h/ Flow, MGD Oil and Grease, mg/1 i/ pH, s.u. Total Suspended Solids, mg/l Total Dissolved Solids, mg/I a/j/ Total Phosphorus (as P) mg/l f! Weekly Weekly Monthly Monthly Quarterly Quarterly Instantaneous Visual Grab Grab Grab Grab Self-monitoring samples taken in compliance with the monitoring requirements specified above shall be taken at the point of discharge prior to entering waters of the State. b. Mineral mining and processing point source category - 40 CFR 436 - subparts E (gypsum), F (asphaltic mineral), G (asbestos and wollastonite), J (barite), K (fluorspar), L (salines from brine lakes), M (borax), N (potash), O (sodium sulfate), V (bentoni[e), W (magnesite), X (diatomite), Y (jade), Z (novaculite), AF (tripoli), and asphalt batch plants located at any facility otherwise covered by this general permit: No monitoring is required (unless specified by the Division). P.n annual report to the Division on whether or not a discharge of process water has taken place at the facility is required (see Part I.D.3.6 of the perntit). 4. Flow D4easurinn Device If not already a part of the permitted facility, within ninety (90) days after the effective date of the certification, a flow measuring device shall be installed to give representative values of effluent quantities at the respective discharge points. A flow measuring device will be applicable et aU designated discharge points of process water. The flow may also be determined by using the pump capacity multiplied by the length of time the pump is operated, provided that the accuracy requirement (see below) is met. When the facility is not operating, and no discharge is occurring (e.g., if i[ is shut down for the winter), a flow measuring device is not required to be on site. A[ [he request of the Water Quality Control Division, or the Environmental Protection Agency, the permittee shall show proof of the accuracy of any Flow-measuring device used in obtaining data submitted in the monitoring report. The Flow-measuring device must indicate values within tau (10) percent of the actual flow being discharged. EFFLUENT LIMITATIONS AND CONDITIONS - STORMWATER DLSCHARGE (This section (I. C) applies to all facilities with a discharge of stormwater.) General Limitations a. Stormwater discharges from the industrial activity shall not cause or threaten to cause pollution, contamination or degradation of any State waters. b. There shall be no discharge of sanitary waste waters from toilets or related facilities. c. No chemicals are to be added to the discharge unless permission for the use of a specific chemical is granted by the permit issuing authority. In granting the use of such chemicals, additional limitations and monitoring requirements may be imposed. d. Bulk storage structures for petroleum products and other chemicals shall have adequate protection so as to prevent any reasopable loss of the material from entering discharged waters or waters of the State.