PERMFILE47866

• Permit No: M1980244
• IBM Index Class Name: Permit File
• Doc Date: 9/3/2002
• Doc Name: Certifcation Report Phase IVa
• From: Cripple Creek & Victor Gold
• To: DMG
• Media Type: D
• Archive: No

L J
4. CONTRACTOR shall protect geotextile from excessive heat, cold, puncture, cutting,
or other damaging or deleterious conditions.
5. CONTRACTOR shall ensure personnel responsible for loading, transport, and
unloading of are familiar with handling and transport constraints imposed by
MANUFACTURER.
B. Acceptance at Site
CQA Monitor shall perform inventory and surface inspection for defects and damage of
all geotextile rolls upon delivery.
2. CONTRACTOR shall unroll and inspect any geotextile roll that may be damaged
below surface.
3. CONTRACTOR shall repair damage resulting from handling and transport of
geotextile at no cost to CC&V. If irreparable, in the opinion of CERTIFYING
ENGINEER, damaged materials shall be replaced at no cost to CC& V.
C. Storage and Protection
]. MANAGER will provide on-site storage area for geotextile rolls from time of delivery
until installation.
•
2. The storage of the materials is the responsibility of CONTRACTOR from the time the
materials are manufactured until the time the completed installation is accepted.
CONTRACTOR is responsible for preparing the storage location and for the
protection of the material from the elements (e.g. ultraviolet light, moisture,
temperature, etc.).
3. After CONTRACTOR has removed material from storage azea, protect geotextile
from puncture, dirt, groundwater, moisture, mud, mechanical abrasion, excessive heat,
ultraviolet light exposure, and other sources of damage.
4. Geotextile shall be supplied in rolls wrapped in relatively impermeable and opaque
protective covers, with straps for unloading.
5. CONTRACTOR shall preserve integrity and readability of the geotextile roll labels,
and store such that MANAGER and CERTIFYING ENGINEER have access to the
package slips or roll labels for each roll to verify roll acceptance.
PART 2: PRODUCTS
2.01 MATERIALS:
A. Twelve-ounce Non-Woven Needle Punched Geotextile:
Geotextile shall be comprised of polyester or polypropylene fibers.
2. Rolls shall be free of holes, contamination, and foreign matter.
3. The geotextile supplied for the project shall meet or exceed the minimum (unless noted
otherwise) roll values shown in the table below:
Section 02777 Page 3 of 5 December 9, 1998
Geotextile Golder Associafes Revision 2