Laserfiche WebLink
378-I1 Pond <br />_ Drainfill shalt be kept from being <br />• contaminated by adjacent soil <br />materials during placement by <br />either placing it in a cleanly <br />excavated trench or by keeping the <br />drain at least 1 ft. above the <br />adjacent earthfill. <br />Selected drainfil{ and backfill <br />material shall be placed around <br />structures, pipe conduits, and <br />antiseep collars at approximately <br />the same rate on all sides to <br />prevent damage from unequal <br />loading. <br />Fill material shall be placed, <br />spread and compacted beginning at <br />the lowest point of the foundation <br />and then bringing it up in <br />horizontal layers thick enough <br />that the required compaction can <br />be obtained. The fill shall be <br />constructed in continuous <br />horizontal layers, if openings or <br />sectionalized fills are required, <br />l.he slope of the bonding surfaces <br />between the embankment in place <br />and the embankment to be placed <br />shall not be steever than a ratio <br />of three horizontal to one <br />vertical. The bonding surface <br />shall be treated the same as that <br />specified for the foundation to <br />insure a good bond with the new <br />fill. <br />and gradation, the more impervious <br />material shall be placed in the <br />center and upstream parts of the <br />fill. If zoned fills of <br />substantially differing materials <br />are specified, the zones shall be <br />placed according to fines and <br />grades shown on the drawings ar as <br />staked in the field. <br />Moisture control <br />The moisture content of the fill <br />material shall be adequate for <br />obtaining good compaction.. <br />Material that is too wet shall be <br />dried to meet this requirement, <br />and material that is too dry shall <br />be wetted and mixed until the <br />desired consistency is met. <br />Compaction <br />Each layer shall be thoroughly <br />compacted by routing construction <br />equipment corrugated or cheeps <br />foot roller, trucks or a heavily <br />loaded disc cultivator over the <br />area. A minimum of 2 longitudinal <br />passes shall be made. teach pass <br />shall consist of at least one <br />passage of an equipment wheel or <br />track over the entire surface of <br />the layer. <br />During construction, the top of <br />the embankment shall be maintained <br />as a horizontal plane the full <br />length and width thereof and no <br />side dumping of materials shall be <br />permitted. <br />The distribution and gradation of <br />materials shall be such that no <br />lenses, pockets, streaks, or <br />layers of material shall differ <br />substantially in texture or <br />gradation from the surrounding <br />aerial. If it is necessary to <br />materials of varying texture <br />If a minimum required density is <br />specified, each layer of fill <br />shall be compacted as necessary to <br />obtain that density. <br />SCS, Colorado. ~_^••-- '~"~ <br />