Laserfiche WebLink
i <br />SECTION 03150 -EXPANSION AND FDtED JOINTS • <br />f <br />PART 1 -GENERAL <br />__ 1.01 Description <br />i <br />This work shall consist of providing open joints, control joints, steel joints, water-• <br />stops, and isolation joints in reasonably close conformity with the locations and <br />j dimensions shown on the drawings and with these specifications. <br />1.02 Submittals <br />Prior to construction of the required joints the Contractor shall submit for approval <br />by the Engineer samples of waterstops, joint fillers, and joint sealers, and shop <br />^ drawings for fabricated steel joints. <br />PART 2 -PRODUCTS <br />f 2.01 Materials <br /> A. W aterstops <br /> 1. Waterstops shall be manufactured from polyvinylchloride conforming <br />r to the Corps of Engineers Specification Number CRD-C 572. • <br /> 2. Manufacturer's shop splices shall be full vulcanized. <br /> 3. All water stops shall be BFG Blue Vinyl Lok-Rib Center Bulb Style as <br />C manufactured by the B. F. Goodrich Company, Burke Vinylok Water <br /> Stop as manufactured by Burke Concrete Accessories, Inc., or an <br /> approved equal. <br /> 4. A certificate shall be furnished with the test sample supplied, stating <br /> that all of the performance requirements specified under paragraph 6 <br /> of the said specification have been complied with. <br /> B. Pre-molded Expansion Joint Filler strips shall conform to ASTM D-1751 car <br /> ASTM D-1752. <br />W C. Expanded Rubber Joint filler shall conform to ASTM D-1056; Grades RE93 <br /> to RE45, SBE43 to SBE45, or SCE43 to SCE45; adhesives shall be as recom- <br /> mended by the manufacturer. <br /> D. PVC and Polyethylene joint fillers shall conform to ASTM D-1667; Graders <br />L VE-43BL to VE-45BL; adhesives shall be as recommended by ttie <br /> manufacturer. <br /> E. Polysulfide sealer shall be a cold applied, two component, self leveling <br /> compound conforming to Federal Specification TT-S-00227E. • <br />,1~ F. Hot-poured joint sealer shall conform to the requirements of AASHTO M17'3 <br />L and shall be heated according to manufacturer's recommendations. <br />L 03150-1 <br />