Laserfiche WebLink
COLORADO <br /> Division of Reclamation, <br /> Mining and Safety <br /> Department of Natural Resources <br /> 1313 Sherman Street, Room 215 <br /> Denver, CO 80203 <br /> September 9, 2019 <br /> Jason Burkey <br /> Oldcastle SW Group dba United Companies of Mesa County <br /> 2273 River Road <br /> Grand Junction,CO 81505 <br /> RE.Otter Creek Pit,File No.M-2012-050, 112 Construction Materials Amendment Application <br /> (AM-1),Adequacy Review#1 <br /> Dear Mr.Burkey: <br /> The Division of Reclamation, Mining and Safety(Division) is in the process of reviewing the above <br /> referenced application in order to ensure that it adequately satisfies the requirements of the <br /> Colorado Land Reclamation Act for the Extraction of Construction Materials (Act) and the <br /> associated Mineral Rules and Regulations of the Colorado Mined Land Reclamation Board for the <br /> Extraction of Construction Materials (Rules). During review of the material submitted,the Division <br /> determined that the following issue(s) of concern shall be adequately addressed before the <br /> application can be considered for approval. <br /> 6.4.1 EXHIBIT A-Legal Description <br /> (1) The legal description must identify the affected land, specify affected areas and be <br /> adequate to field locate the property. Description shall be by(a),township,range,and <br /> section,to at least the nearest quarter-quarter section and (b),location of the main <br /> entrance to the site reported as latitude and longitude, or the Universal Transverse <br /> Mercator(UTM) Grid as determined from a USGS topographic map.A metes and bounds <br /> survey description is acceptable in lieu of township,range,and section.Where available, <br /> the street address or lot number(s) shall be given.This information may be available from <br /> the County Assessor's office or U.S.Geological Survey(USGS) maps. <br /> (2) The main entrance to the mine site shall be located based on a USGS topographic map <br /> showing latitude and longitude or Universal Transverse Mercator(UTM).The operator <br /> will need to specify coordinates of latitude and longitude in degrees,minutes and seconds <br /> or in decimal degrees to an accuracy of at least five (5) decimal places (e.g.,latitude <br /> 37.12345 N,longitude 104.45678 W). For UTM,the operator will need to specify North <br /> of,coto <br /> red` <br /> 1313 Sherman Street, Room 215, Denver, CO 80203 P 303.866.3567F 303.832.8106 http://mining.state.co.us <br /> * * . <br /> Jared S. Polis, Governor I Dan Gibbs, Executive Director I Virginia Brannon,Director # <br /> *1876 <br />