Laserfiche WebLink
2. Provide cyanacrylate adhesive (super glue) for butt jointing and mitering. <br />3. Cut ends square (or at proper angle for mitered corners) and fit splices together <br />without overlaps. <br />4. Seal watertight any exposed cells of the water stop recommended by manufacturer. <br />3.4 EXPANSION JOINT INSTALLATION <br />A. General: <br />1. Place bond breaker above and below water stop when premolded joint filler and <br />pourable joint filler is not used. <br />2. Premolded Joint Filler: <br />a. Sufficient in width to completely fill the joint space where shown. <br />b. If a water stop is in the joint, cut premolded joint filler to butt tightly against the <br />water stop and the side forms. <br />3. Precut premolded joint filler to the required depth at locations where joint filler or <br />sealant is to be applied. <br />4. Form cavities for joint filler with either precut, premolded joint filler, or smooth <br />removable accurately shaped material. Entire joint above water stop, in slabs, shall <br />be formed and removed so that entire space down to water stop can be filled with the <br />pourable joint filler. <br />5. Vibrate concrete thoroughly along the joint form to produce a dense, smooth surface. <br />Expansion, Construction and Control Joints February 2017 03251-7 <br />