2016-07-11_REVISION - M1980244

• Permit No: M1980244
• IBM Index Class Name: Revision
• Doc Date: 7/11/2016
• Doc Name: TR78 Corrected
• From: Newmont
• To: DRMS
• Type & Sequence: TR78
• Email Name: TC1
• Media Type: D
• Archive: No

Newmont-Cripple Creek&Victor Gold Mine
Technical Specification No.02776-O.DOCX
Squaw Gulch VLF ■
Project No.475.0106.006
June 15,2016
C. Thickness
d. Roll number
e. Batch or lot number
f. Panel number(when applicable)
g. Roll dimensions
2. CONTRACTOR shall ensure that geomembrane rolls are properly loaded and secured
to prevent damage during transit.
3. CONTRACTOR shall protect geomembrane from excessive heat, cold, puncture,
cutting, or other damaging or deleterious conditions.
4. CONTRACTOR shall ensure personnel responsible for loading, transport and
unloading of geomembrane are fully aware of the consequences of damage to
geomembrane, and are familiar with handling and transport constraints imposed by
MANUFACTURER
B. Acceptance at Site
1. CQA Monitor shall perform inventory and surface inspection for defects and damage
of all geomembrane rolls upon delivery.
2. CONTRACTOR shall unroll and inspect any geomembrane roll that may be damaged
below surface.
3. CONTRACTOR shall repair damage resulting from handling and transport of
geomembranes at no additional cost to CC&V. If irreparable, in the opinion of
CERTIFYING ENGINEER, damaged materials shall be replaced at no additional cost to
CC&V.
C. Storage and Protection
1. MANAGER will provide area for on-site storage of the geomembrane rolls from time
of delivery until installation.
2. The storage and handling of the materials is the responsibility of CONTRACTOR from
the time the materials are manufactured until the time the completed installation is
accepted. CONTRACTOR is responsible for preparing the storage location and for the
protection of the materials from the elements (e.g. ultraviolet light, moisture,
temperature, etc.).
3. After CONTRACTOR has removed material from storage, CONTRACTOR shall protect
geomembrane from puncture, dirt, grease, water, moisture, mud, mechanical
abrasion, excessive heat, and other sources of damage.
4. CONTRACTOR shall preserve integrity and readability of the geomembrane roll
labels, and store the rolls such that MANAGER and CERTIFYING ENGINEER have
access to the package slips or roll labels for each roll to verify roll acceptance.
5. The rolls shall be stored on a prepared surface (not wooden pallets) and should not
be stacked more than three rolls high. If the rolls are stacked higher than two rolls
Page 6