2015-06-17_REPORT - M1990057

• Permit No: M1990057
• IBM Index Class Name: REPORT
• Doc Date: 6/17/2015
• Doc Name: Report
• From: Union Milling Co, LLC
• To: DRMS
• Email Name: DMC
• Media Type: D
• Archive: No

Permit M1990-057 2
Leadville Mill, Union Milling Company, LLC
June 17, 2015
Annual Report
The 110d Annual Report Form submitted along with our Annual Fee Invoice and CDRMS Report
Request dated 1 May 2015 is completed, signed and included with this documentation. See Page
7.
Property
Permit M-1990-057 includes the Leadville Mill. The Hopemore Shaft has submitted an application
for a separate permit. The permit operator is:
Union Milling Company, LLC (UMC)
Nick Michael, Member
P. O. Box 620490
Littleton, CO 80162-0490
303-947-3499
The Leadville Mill is located in the Northeast Quarter of the Northeast Quarter of Section 33, and
the Southeast Quarter of the Southeast Quarter of Section 28, Township 9 South, Range 80 West.
The county designated address is 13815 Highway 24, Lake County, Colorado. The owner of the
Leadville Mill is:
Constructive Investments, LLC
Nick Michael, Member
PO Box 620490
Littleton, CO 80162-0490
Activities: June 18, 2014 to June 17, 2015
The mill remained idle, on care and maintenance status, with no production or milling occurring
in the last 12 month period. Care and maintenance were the only activities that occurred during
the past year at the mill.
The Leadville Mill activities for the past 12 months are presented below.
1. Groundwater Quality Sampling. UMC completed 2 new monitoring wells (MW -2 and MW -
3) on 24 October, 2014.
On 28 May 2014 UMC submitted a proposal ("Leadville Mill, M1990-057, Proposed
Monitoring Well Locations") to CDRMS. The proposal was to construct Monitoring Well
(MW) No. 2 as the down -gradient well at the extreme southwest corner of the property,
and MW -3 as the up -gradient well northeast of the TSF near our lower mill access road.
MW -2 is at approximate coordinates N39013'44.17", W106°19'59.98"", elevation 9701ft,
and MW -3 is at approximate coordinates N39013'49.87", W106019'53.61", elevation
9744ft (assuming coordinates as reported by Google Earth). Locations are shown on our
updated Exhibit provided with this report.
UMC received a verbal "OK" accepting the proposal for the well locations; however no
formal letter was received by UMC.
UMC, applied and obtained permits from the State Engineer (Permit 295655 for MW -2,
and 295654 for MW -3) on 11 September 2014. We then secured a drilling contractor
who completed the wells on 14 October 2014. UMC then completed the monitoring well
project on 24 October 2014 by installing well pumps.
Photos of MW -2 and MW -3 are provided below.