2015-03-23_PERMIT FILE - M2015008 ‎(2)‎

• Permit No: M2015008
• IBM Index Class Name: PERMIT FILE
• Doc Date: 3/23/2015
• Doc Name: Revisions Application
• From: Kirkland Construction
• To: DRMS
• Email Name: PSH
• Email Name: TAK
• Media Type: D
• Archive: No

SECTION 5.6: SEDIMENT CONTROL
SC 8: STABILIZED CONSTRUCTION ENTRANCE
SC 8: Stabilized Construction Entrance
Description A stabilized layer of
aggregate underlined
with a geotextile and
located where traffic
enters or exits the
construction site.
Applications
Installation
Maintenance
and Inspection
• Used to reduce the
amount of mud
tracked onto paved
public roads by
vehicles or runoff
leaving the
construction site.
• Used as a temporary
feature.
• The entrance must extend the full width of the ingress/ egress area and
have a minimum width of 12 feet and a minimum length of 70 feet (see
Figure SC 8.1).
• Area of the entrance must be excavated a minimum of 12 inches. The
geotextile will then be placed and covered with a minimum 12 -inch layer
of aggregate. The aggregate shall be equal to or greater than 3 inches (see
Figure SC 8.1).
• The structure shall be maintained daily.
• Stone shall be added and repairs performed as conditions require.
• Any mud or dirt tracked onto paved surfaces should be cleaned up
within 24 hours.
• Damaged curb, gutter or sidewalk should be replaced.
5-67
rx:
f'
• The entrance must extend the full width of the ingress/ egress area and
have a minimum width of 12 feet and a minimum length of 70 feet (see
Figure SC 8.1).
• Area of the entrance must be excavated a minimum of 12 inches. The
geotextile will then be placed and covered with a minimum 12 -inch layer
of aggregate. The aggregate shall be equal to or greater than 3 inches (see
Figure SC 8.1).
• The structure shall be maintained daily.
• Stone shall be added and repairs performed as conditions require.
• Any mud or dirt tracked onto paved surfaces should be cleaned up
within 24 hours.
• Damaged curb, gutter or sidewalk should be replaced.
5-67