2013-10-01_REVISION - M1980244

• Permit No: M1980244
• IBM Index Class Name: REVISION
• Doc Date: 10/1/2013
• Doc Name: Response to Adequacy
• From: CC&V
• To: DRMS
• Type & Sequence: TR68
• Email Name: TC1
• Media Type: D
• Archive: No

TECHNICAL SPECIFICATIONS
b. Product identification
C. Thickness
d. Roll number
e. Batch or lot number
f. Panel number (when applicable)
g. Roll dimensions
2. CONTRACTOR shall ensure that geomembrane rolls are properly loaded and secured to prevent
damage during transit.
3. CONTRACTOR shall protect geomembrane from excessive heat, cold, puncture, cutting, or
other damaging or deleterious conditions.
4. CONTRACTOR shall ensure personnel responsible for loading, transport and unloading of
geomembrane are fully aware of the consequences of damage to geomembrane, and are familiar
with handling and transport constraints imposed by MANUFACTURER.
B. Acceptance at Site
1. CQA MONITOR shall perform inventory and surface inspection for defects and damage of all
geomembrane rolls upon delivery.
2. CONTRACTOR shall unroll and inspect any geomembrane roll that may be damaged below
surface.
3. CONTRACTOR shall repair damage resulting from handling and transport of geomembranes at
no additional cost to CC &V. If irreparable, in the opinion of CERTIFYING ENGINEER,
damaged materials shall be replaced at no additional cost to CC &V.
C. Storage and Protection
1. MANAGER will provide area for on -site storage of the geomembrane rolls from time of delivery
until installation.
2. The storage and handling of the materials is the responsibility of CONTRACTOR from the time
the materials are manufactured until the time the completed installation is accepted.
CONTRACTOR is responsible for preparing the storage location and for the protection of the
materials from the elements (e.g. ultraviolet light, moisture, temperature, etc.).
3. After CONTRACTOR has removed material from storage, CONTRACTOR shall protect
geomembrane from puncture, dirt, grease, water, moisture, mud, mechanical abrasion, excessive
heat, and other sources of damage.
4. CONTRACTOR shall preserve integrity and readability of the geomembrane roll labels, and
store the rolls such that MANAGER and CERTIFYING ENGINEER have access to the
package slips or roll labels for each roll to verify roll acceptance.
5. The rolls shall be stored on a prepared surface (not wooden pallets) and should not be stacked
more than two rolls high.
1.5 SITE CONDITIONS
A. Geomembrane Deployment
1. Do not proceed with deployment at an ambient temperature below 14° F or above 100° F unless
otherwise authorized, in writing, by MANAGER, DESIGN ENGINEER, and CERTIFYING
ENGINEER. Temperature monitoring shall be performed by the CQA MONITOR.
Geomembrane August 28, 2013
02776.1 -5 Revision 0
S \Projects \1550 - CC &V Field Spt CQA PSES Bldg \8 0 Project Engineering and Design \8 2 Specificanons\PSES Pipe Rack Liner Extension Specifications \02776 1 Geomembrane docx