2012-12-27_REPORT - M1980244 ‎(17)‎

• Permit No: M1980244
• IBM Index Class Name: REPORT
• Doc Date: 12/27/2012
• Doc Name: QA Mon. & Test Results, Ph. 5 Berm Mod.-Apend. E Specs.
• From: CC&V
• To: DRMS
• Email Name: TC1
• Media Type: D
• Archive: No

Property
Test Method
40 mil LLDPE
Smooth
80 mil LLDPE
Textured
80 mil LLDPE
Thickness (mils)
Compound Density (g/cc)
Carbon Black Content ( %)
GRI -GM8
ASTM D 1505
ASTM D 1603
38 (min) /40 (min)
0.939 (max)
2 -3
72 (min) /80 (min)
0.939 (max)
2 -3
72 (min) /80 (min)
0.939 (max)
2 -3
Tensile Properties
1. Ultimate Tensile Strength (ppi)
2. Ultimate Elongation ( %)(2.5" gauge)
ASTM D 638, NSF 54
ASTM D 638, NSF 54
140 (min)
650 (min)
304 (min)
800 (min)
169 (min)
300 (min)
Puncture Resistance (lbs.)
ASTM D 4833
55 (min)
112 (min)
96 (min)
Field Seam Properties
1. Shear Strength (ppi)
2. Peel Strength (Inside and outside tracks
for fusion welds)
ASTM D4437 (modified NSF 54)
ASTM D4437 (modified NSF 54)
56 (min)
48 (min), FTB 5 ' 6,7
120 (min)
100 (min), FTB 5 ' 6 ' 7
120 (min)
100 (min), FTB 5,6,7
Section 02776
Geomembrane
C \AMEC_CC &V\Phase 5 VLF \PSSA Cert Report\Appendices\Appendix E \SPECS \02776,r1 doc
TYPICAL PROPERTIES -TABLE 2.01 -A
Notes:
LLDPE refers to Linear Low Density Polyethylene and VLDPE
refers to Very Low Density Polyethylene.
2
First value represents lowest individual value. Second value
represents minimum average roll value.
3 Core Thickness, exclusive of textured surface.
4 Seam strength refers to both fusion and extruded seams for LLDPE
to LLDPE welds.
5 If peel strength exceeds ultimate tensile strength of the sheet but the
sample fails FTB, the test will be considered a pass.
6 Federal Test Method Standards.
7 Film Tear Bond (FTB) is defined as failure of one of the sheets by
tearing, instead of separating from the other sheet at the weld
interface area (sheet fails before weld).
Page 9 of 22 September 3, 2008
Revision 1