Laserfiche WebLink
SPECIFICATION C <br /> PIPING <br /> 1 SCOPE <br /> The work covered by this specification consists of furnishing all materials and <br /> performing all operations required for the installation of the piping as shown on the <br /> Drawings and subject to the terms of the Contract, including, but not necessarily <br /> limited to the following work. <br /> 1.1 Furnish and install approximately one hundred and ninety five lineal feet <br /> (195 LF) of twenty-four-inch (24") diameter reinforced concrete pipe, <br /> twenty-four-inch by fifteen-inch (24" x 15") eccentric reducer, and fifteen- <br /> inch (15") sixty-three point four degree (63.4°) elbow for the inlet. <br /> 1.2 Furnish and install approximately twenty lineal feet (20 feet) of four-inch <br /> (4") diameter and twenty lineal feet (20 LF) of slotted four-inch (4") <br /> diameter PVC drain pipe and fittings for the outlet headwall drain. <br /> 1.3 Furnish and install approximately one hundred lineal feet (100 LF) of four- <br /> inch (4") diameter steel vent pipe and fittings for outlet gate. <br /> 1.4 Furnish and install approximately one hundred lineal feet (100 LF) of three- <br /> inch (3") diameter steel gage pipe with elbow and tees. <br /> 2 GENERAL <br /> 2.1 All piping shall be constructed at the locations indicated on the Drawings <br /> or at such alternative locations dictated by field conditions and acceptable <br /> to the Engineer. <br /> 2.2 All materials shall be installed in strict accordance with the manufacturer's <br /> recommendations, as applicable. <br /> 3 APPLICABLE STANDARDS <br /> 3.1 AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) <br /> ASTM A 53 Specification for Pipe Steel, Black and Hot-Dipped, <br /> Zinc-Coated, Welded and Seamless. <br /> SPECIFICATION C- PIPING <br /> PAGE 1 <br />