Laserfiche WebLink
Tank Contents <br />Capacity (gallons, unless <br />otherwise specified) <br />LT 40102 <br />Diesel Fuel <br />3000 <br />Various oils <br />2765 <br />Antifreeze <br />220 <br />LT 40103 <br />Diesel Fuel <br />8000 <br />Various oils <br />2765 <br />Antifreeze <br />220 <br />4.1.5.2 Quantities of Material Stored and Used in Mobile Equipment Tanks <br />Table 7 . Mobile Fueling Equipment Products in Tanks <br />4.1.5.3 Spill Potential of Mobile Equipment <br />The most likely amount of fuel or oil spilled from mobile equipment is on the order of 1 to 50 gallons. <br />A typical spill might involve a hydraulic line break, and this could occur anywhere on the site. Flow <br />direction is even more dependent on where the line break or spill occurs. In general, the site's ground <br />surface is loose native soil or crushed rock, and flow -paths are typically directed to containments. <br />These factors are helpful in spill containment, therefore it would be unlikely that a spill would report off <br />the site before it could be properly cleaned up and disposed. <br />4.1.5.4 Spill Prevention and Control for Mobile Equipment <br />Where oil product or antifreeze transfers occur in the field (not inside secondary containment), field <br />personnel will use containment buckets, drip trays, or absorbents will be used to catch any spillage. <br />During these transfers of liquids, hoses, nozzles, pumps, flanges, tanks, and piping will be inspected <br />and any significant deterioration will be reported to the maintenance department for repair or <br />replacement as needed. <br />In the Preamble to 40 CFR Part 112 as given in the Federal Register, July 17, 2002, pages 47054 -5, it <br />states: "Facilities that use oil operationally include electrical substations, facilities containing electrical <br />transformers, and certain hydraulic or manufacturing equipment. The requirements for bulk storage <br />containers may not always apply to these facilities.... Facilities with equipment containing oil for <br />ancillary purposes are not required to provide the secondary containment required for bulk <br />storage facilities 0112.8(c))." Based on the preceding regulatory discussion, secondary <br />containment is not required for mobile operating equipment. "The general requirement for secondary <br />containment, which can be provided by various means including drainage systems, spill diversion <br />ponds, etc., will provide for safety and also meet the needs of Section 311 (j)1(c) of the CWA" <br />according to the discussion on page 47055 of the July 17, 2002 Federal Register. The containment <br />structures described in other sections of this SRP /SPCC Plan plus drainage controls included in the <br />site storm water pollution prevention plan (SWPPP) meet the intent of the general secondary <br />containment requirement. <br />4.1.5.5 Spill Countermeasures (Clean -up Procedures) for Mobile Equipment <br />Section 3.2 provides the general spill response procedures for use involving spills around mobile <br />equipment. The following narrative provides additional detail on spill clean up. <br />Spill Response Plan <br />EMS: AGANA/CCV <br />G: \EMS \Plans\Emergency Response Plans \SRP Plan \SRP Plan.doc <br />Printed Copies are Uncontrolled <br />August 17, 2010 <br />Doc. # E -006 <br />Revision 05 <br />24 <br />