Laserfiche WebLink
(UP 06 <br />8.23.07 RIPRAP PROTECTION - Both the inlet and outlet ends of all culverts shall be <br />protected by riprap. The riprap shall be installed per detail on UP Company Bridge Standard <br />Plan No. 680000, Sheet 2 of 2 or as shown on the Drawings and Specifications. <br />8.23.08 SMOOTH STEEL PIPE (SSP) - NOT JACK AND BORED - When smooth steel pipe <br />is to be extended, by normal methods, from the end of the jack and bored sections, or is placed <br />entirely by nonnal methods Sections 8.21.00 through Sections 8.21.10 shall be followed for any <br />items not specifically covered by Sections 8.23.00 to Sections 8.23.06. <br />8.22.04 SHORING - When working near UP tracks, temporary shoring may be required. UP's <br />"Guidelines for Temporary Shoring" can be found on the Internet at: <br />littp:,',Iwww.uprr.com/aboutup /operations /§Recs!'index.slitm]. <br />Also see Union Pacific Railroad/ Burlington Northern Railroad Common Standard Plan No. <br />710000, Sheet 1 of 1 and Plan No. 710001, Sheet 1 of 1. <br />8.24.00 RIGHT OF WAY FENCES AND GATES <br />The extent of die Standard Right of Way fence and gates is as indicated on the Drawings and <br />Specifications or as designated by the Engineer and in accordance with typical details shown on UP <br />Engineering Standard Drawing No. 0075. <br />8.24.01 MATERIALS <br />Hog tight, woven wire - A twenty six inch (26 ") woven wire galvanized steel fabric is to be used <br />with seven horizontal bars of No. 9 galvanized wire and stays on six inch (6 ") centers. Weight is <br />approximately 266 pounds per 20 rod roll. <br />Line Posts - Use painted studded tee steel fence posts seven foot (7') long, with anchor plate, <br />spaced as shown on UP Standard Drawing NO. 0075. Approximate weight 9.98 pounds each. <br />Corner Post - Use five percent (5 %) solution penta treated wood posts, six inches (6") in diameter <br />by nine foot (9') long or 7" x 9" second hand wood ties. <br />Brace Panel Posts - Use five percent (5 %) solution penta treated wood posts, six inches (6 ") in <br />diameter by nine foot (9') long or 7" x 9" second hand wood tics. <br />Horizontal Brace Posts - Use five percent (5 %) solution penta treated wood posts, four inches <br />(4 ") in diameter or 4" x 4" by nine foot (8) long. <br />Gate Posts - Use 7" x 9" x 9' second hand ties. Each side of gate shall have a brace panel <br />constructed to support gate. <br />Barbed Wire - Shall be two - strand 12.5 galvanized wire, twisted, with 14 -gauge 4 -point barbs <br />spaced not more than 5 inches center to center. Metal and finish to match fabric ( gab, anized). <br />Diagonal Tie Wire - Use double number 8 galvanized steel wire twisted. <br />41 <br />