2011-02-25_REPORT - C1994082 - Laserfiche WebLink

Home Browse Search

- Spoil Spring 2 (YSSPG2). This spoil spring was discovered in May 2005 below Stock Pond 011A (i.e., above NPDES Pond 011). It is normally dry in the fall. Its TDS plot displays a stable trend. - Spoil Spring 3 (YSSPG3). This spoil spring was discovered in September 2005 above NPDES Pond 012. Its TDS plot displays an increasing trend. - Spoil Spring 4 (YSSPG4). This spoil spring was discovered in June 2006, in the main channel that feeds NPDES Pond 012. It is located to the north of Spoil Spring 3. Its TDS plot displays a decreasing trend. comparison of Surface Water Quality to Water Use Standards. SCC has compiled a list of surface water standards for agricultural uses (Table 11). This list is composed of CDPHE surface water agricultural use standards (CDPHE, Reg.31, November 2009). Table 12 provides a comparison of surface water quality (including springs) to agricultural standards. This Paradox database generated table does not include the units of concentration (mg/l or ug/1) for each parameter. The units used for each parameter are the same as those listed on the standards table (Table 11) and are also the same as those used in the water quality reports. The frequency column on Table 12 indicates, in this order: uncensored, that is, the number of exceedances above the Method Detection Limit (MDL) / the number of exceedances between the MDL and the Practical Quantitation Level (PQL) / censored, that' is, the number of sample values below the MDL but the MDL was higher than the standard / the total number of samples. Below is a summary of standards that were exceeded. Given in parenthesis is the source and use of each standard. Although the CDPHE does not indicate between livestock and irrigation uses in their surface water agricultural standards, they have done so in their similar ground water agricultural standards (see Table 5). For the sake of discussion, SCC chooses to use those ground water use standards classifications 11