Laserfiche WebLink
Product <br />Bulletin (,O',.DowAgroSciences <br />Dow AgroSciences LLC 9330 Zionsville Road Indianapolis, IN 46268 -1054 USA <br />Garlon* 4 <br />EPA Reg. No. 62719-40 <br />2(ee) Recommendation t <br />For Distribution and Use in All States Except California <br />For Basal Bark, Dormant Brush and Cut Stump Applications to Control Woody <br />Vegetation in Rights -of -Way <br />6 <br />ATTENTION <br />• tThis recommendation Is made as permitted under FIFRA 2(se) and has not been reviewed or <br />approved by the EPA. <br />• This recommendation must be in the possession of the user at the time of application. <br />• Read the label affixed to the container for Garlon` 4 specialty herbicide before applying. Carefully <br />follow all precautionary statements and applicable use directions except as speed below.. <br />• Except as described this Section 2(ee) recommendation, use of Garlon 4 according to this product <br />bulletin is subject to all use precautions and limitations imposed by the label affixed to the product <br />container. <br />Directions for Use <br />Basal Bark and Dormant Brush Treatments <br />To control susceptible woody plants in rights -of -way use Garlon 4 in oil or oil -water mixtures prepared <br />and applied as described below. When preparing mixtures, use as oils either a commercially available <br />basal oil, diesel fuel, No. 1 or No. 2 fuel oil, or kerosene. Substitute other oils or diluents only as <br />recommended by the oil or diluent's manufacturer. When mixing with a basal oil or other oils or diluents, <br />read and follow the use directions and precautions on the product label prepared by the oil or diluent's <br />manufacturer. <br />Oil Mixture Sprays <br />Add Garlon 4 to the required amount of oil in the spray tank or mixing tank and mix thoroughly. If the. <br />mixture stands over 4 hours, reagitation is required. <br />Oil Mixtures of Garlon 4 and Tordon K: Garlon 4 and Tordon• K specialty herbicide may be used in <br />tank mix combination for basal bark treatment of woody plants. These herbicides are incompatible and <br />will not form a stable mixture when mixed together directly in oil. Stable tank mixtures for basal bark <br />application can be made if each product is first combined with a compatibility agent prior to final mixing in <br />the desired ratio. (See elsewhere in this product bulletin for mixing instructions.) <br />Oil -Water Mixture Sprays <br />Premix the Garlon 4, oil and surfactant in a separate container. Do not allow any water or mixtures <br />containing water to get into the Garlon 4 or the premix. Fill the spray tank about half full with water, then <br />slowly add the premix with continuous agitation and complete filling the tank with water. Continue <br />moderate agitation. Note: If the premix Is put in the tank without any water, the first water added may <br />form a thick "invert" (water in oil) emulsion which will be hard to break. <br />Basal Bark Treatment <br />To control susceptible woody plants with stems less than 6 inches in basal diameter, mix 1 to 5 gallons of <br />Garlon 4 in enough oil to make 100 gallons of spray mixture. Apply with knapsack sprayer or power <br />Page 1 of 2 <br />